Tavistock KOBE 450 Installation & Care Instructions

Before you start
It is recommended that the unit and basin are secured to a suitably reinforced wall to ensure stability. The wall plugs supplied are only suitable
for solid stone / brick walls. For plasterboard walls use specialist wall plugs along with supplementary wall strengthening as units can be very
heavy. Seek advice from a specialist about the suitability of fixings to be used. Wear suitable eye protection when drilling. Take care when
using power tools near water - the use of a residual current device (RCD) is recommended. Beware of hidden pipes or cables. Take care when
drilling tiled surfaces as the drill might slip. Use a piece of masking tape to prevent the drill from wandering.
1
Hinge Adjustment
Hinges may require adjustment for both the doors to fit neatly together. This is achieved with the adjustable soft close hinges using the
adjustment screws A and B (see instructions below). To access these you may first have to remove the screw cap cover. The hinges also
feature a quick release mechanism to quickly and easily detach the door from the furniture frame.
Screw A offers left / right adjustment for levelling up the doors (Adjustment 1).
Screw B offers forward / back adjustment (Adjustment 2).
Button C is the quick release, press this on both hinges to remove a door by releasing the hinges from their mounting plates.
3
Door
Tavistock, Brassmill Lane Trading Estate, Bath, BA1 3JF
T. 01225 787870 | F. 01225 448877 | E. tavistock@roperrhodes.co.uk | W. www.tavistock-bathrooms.co.uk
KOBE 450 FLOORSTANDING UNIT inc. BASIN
Installation & care instructions
Please retain for future reference
Mark the location of each of the wall mounting
plates ensuring that they are positioned inside
the sidewalls of the vanity unit. We would
recommend the height is set such that the
overall height including the basin is 860mm. For
each mounting plate drill two holes in the marked
positions using a 8mm drill bit to a depth of
55mm.
A B C
Furniture Frame
2
C
A
4
Adjustment 1
B
Locate the hangers onto the
wall mounting plates. Wall
hangers not only tighten the
unit against the wall (Screw
A) but also offer up/down
adjustment to fine-tune the
fixing position (Screw B).
Finally fold over flap C to
conceal the adjustment
screws on the wall hanger.
Adjustment 2
REF: KFS45x | 07.11 V2.00