scope Genisys Product Instructions

LENS SWAP
RX ADAPTOR FITTING
REMOVING RX ADAPTOR
Lbfier inee hnm h_ _kZf^ !pbma hnm `Zld^m Ûmm^]"
GASKET FITTING ON GENISYS PLUS
3
2
REMOVING GASKET
1. Pull out gasket frame from one side
2. Repeat step 1 on opposite side
3. Pull out middle section
genisys plus
Product
instructions
REMOVING LENS
1.Fold each end of temples inwards and press down as shown
to disconnect locking mechanism
2. Take out lens
INSERTING LENS
1.Fold each end of temples inwards and press down on locking
mechanism to disconnect from frame.
2.Align lens into frame
3.Extend temple to lock lens into position.
4. Repeat steps for opposite side
REMOVING TEMPLE
INSERTING RX
ADAPTOR
1. Remove gasket
from frame
2. Align Rx adaptor
connecting pin with
frame and click into
position
,' K^&Ûm `Zld^m bgmh
position
1
scopeoptics.com.au
1
2
INSERTING GASKET
*' :eb`g fb]]e^ l^\mbhg pbma _kZf^ Zg] ik^ll Ûkfer
2. Press down on one side until frames click into
position
3. Repeat step 2 on opposite side
*'Ik^ll Ûkfer hg bgg^k m^fie^
as shown to disconnect
locking mechanism
REFIT TEMPLE OR ELASTIC
STRAP
Lbfier \eb\d ^g]l h_ m^fie^ hk
elastic strap into frame until
locked into position
3