Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Noria ECO:100
- Page 1 INSTALLATION & OPERATION ECO:100 ECO:150...
- Page 2 The Noria ECO difference continues with the use of stainless steel shafts for strength; larger hair and lint pots reduce the need for frequent cleaning. The research invested in Noria ECO pumps is reflected in the user-friendly, easy to open inspection lids and barrel unions.
-
Page 3: Installation
INSTALLATION The pump should be installed on a hard surface such as a concrete slab or paver. The pump should be installed in a well ventilated enclosure that is resistant to flooding or other water damage. Place the pump in the position required ensuring there is at least 100mm of spacing between the fan cowling and the wall of the enclosure. -
Page 4: Start-Up Procedure
START-UP PROCEDURE Your ECO pump (variable speed pump) is designed for maximum energy efficiency whilst still keeping your pool crystal clear. To maximise the energy efficiency, the ECO pump should be run at the lowest speed setting possible to efficiently filter your pool water. It is recommended that the first speed setting (Green Button) should be set to this filtration speed and used for at least 6-8 hours per day, whilst the second speed setting (Pink Button) is set for use only with automatic suction cleaners and used once a week only. -
Page 5: Setting The Speed
SETTING THE SPEED Normal Operation Mode at startup Press Button: For ECO Mode (LED will flash when selected) For MEDIUM Mode (LED will flash when selected) For HIGH Mode (LED will flash when selected) Off Button (LED will flash when selected) Adjustable Speed Mode: (this feature is available following the 5 minute priming period) Press Button:... -
Page 6: Pump Care
PUMP CARE CLEANING THE BASKET Switch off the pump at the power supply Close any valves on the pipe work Unscrew the lid locking ring and remove the lid Remove the pump basket Empty debris Refit the basket Refit the lid and tighten lid locking ring Open the valves on the pipe work Switch on at the power supply LEAKS... - Page 7 PUMP CARE MOTOR The motor should be in a well ventilated area free of debris. It is essential that the area is dry as water can cause damage to the electrics. The motor is fitted with a thermal overload switch and may cut out if the pump overheats. It will automatically reset itself when the motor cools.
-
Page 8: Warranty
PRECAUTIONS This appliance must be installed by a qualified service technician. When installing the appliance, ensure all parts are installed in the correct zone in accordance with the wiring rules. Refer to AS/NZS 3000. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.