Installing your remote control The remote control can be used to switch your shower on and off without reaching into the showering area. It’s wireless, for a simple installation. Once your shower has been installed, decide where you would like to position the remote control.
Pairing your remote control We recommend charging the battery prior to pairing the remote. When you are ready to pair your remote control, wake up the controller and navigate to the Settings menu. Move the lever to navigate to Pair a remote. Push the lever to enter.
Using your remote control Switching shower on To switch on your shower, press the button on the remote control. The white LED light will light up and start to flash. It will continue to flash until the water has reached temperature. Once the Shower warming up water has reached temperature, the white LED light will stop flashing and remain on for a further...
Charging the battery Before you use the remote control for the first time, you will need to charge the battery. Charging the battery The remote control is supplied with a micro USB charging cable. This is suitable for use with any CE marked USB mains charger. Whilst charging, a red LED light will be illuminated.
SmartValve, complies with the essential requirements and other relevant provisions of the Low Voltage Directive (2014/35/EU), the EMC Directive (2014/30/EU) and the RED Directive (2014/53/EU). Q5603 Part No 706293 Issue 02 Mar 22...