Axis Scope and Axis Proton each have a small half-rack footprint, so they can sit on a desktop or share a rack shelf with a half-rack SoundGrid server or another device. Axis Scope is 2U tall, Axis Proton is 1U. They have ample USB and HDMI connectors, as well as two Ethernet ports, so you can connect all the devices you need to run a show.
Page 3
RJ-45 Gb Ethernet connector. Use this 1 Gb port for all non- Network port SoundGrid networks, including internet. This 1 Gb etherCON port connects to the SoundGrid network Waves SoundGrid network port switch. Do not use this port for other purposes. Axis Scope and Axis Proton / Quick Start Guide...
Page 4
RJ-45 Gb Ethernet connector. Use this 1 Gb port for all non- Network port SoundGrid networks, including internet. This 1 Gb port connects to the SoundGrid network switch. Waves SoundGrid network port Do not use this port for other purposes. Axis Scope and Axis Proton / Quick Start Guide...
Page 5
Setup Guide Follow these steps to prepare your Axis computer for operation with Waves applications. ARDWARE ONNECTIONS 1. Connect the power cable to mains for the computer and all devices. All SoundGrid hardware devices must be grounded (earthed) according to local regulations.
Page 6
Waves Software Axis Scope and Axis Proton come with Waves v13 software preinstalled. If your Waves licenses are stored on a USB flash drive (“disk on key”), simply insert the drive into an Axis USB port and then open LV1 or another Waves application.
For the SoundGrid network to operate properly, device firmware must be up to date with the eMotion LV1 application software that’s currently running. If these are not in sync, you will be prompted to update the firmware. Axis Scope and Axis Proton / Quick Start Guide...