NICOR LED ECL3 Installation Instructions

READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
• Review the diagrams thoroughly before beginning.
• All electrical connections must be in accordance with local codes, ordinances, and the National Electric code.
• Disconnect power at fuse or circuit breaker before installing or servicing.
• Do not use outdoors.
• Do not let power supply cords touch hot surfaces.
• Do not mount near gas or electric heaters.
• Equipment should be mounted in location and at heights where it will not readily be subject to tampering by unauthorized personnel.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
• Do not use this equipment for other than intended use.
• All servicing should be performed by qualified personnel only.
• Allow battery to charge for 24 hours before first use.
• Max mounting height 17ft
SAVE THESE INSTRUCTIONS
What's In The Box
One (1) ECL3
Installing the ECL3
Preparation
1
• Carefully unpack the exit sign from its packaging.
• Inspect product for defects due to shipping.
• Use screwdriver to carefully remove the front faceplate (See Figure 1)
Mounting and Wiring
Wall Mount (See Figure 2)
• Use screwdriver to carefully remove the front faceplate.
• Remove the knock out hole on the center of back plate. Then
remove the oblong knock outs on the back plate that correspond to
junction box holes to be used.
• Remove the side hole plugs from the housing and snap the lamp
heads onto the unit.
• Connect the lamp head wiring to the circuit board.
• Route supply wiring through the center hole and into the housing.
• Install the fixture on the junction box using the (2) included screws
(#8-32)
• Connect the wiring per the wiring diagram and push excess wire
into the junction box.
• Attach the battery connector to the circuit board.
• Snap out the desired chevron marking(s) from the front faceplate,
reinstall the faceplate and adjust the direction of the lamp heads as
needed.
NICOR, Inc. 2200 Midtown Place NE, Albuquerque, NM 87107 P: 800.821.6283 F: 800.892.8393 www.nicorlighting.com July 26, 2021 10:46 AM
ECL3
One (1) Mounting Kit
Make sure all power is turned off before beginning installation
Slim LED Combo Exit Sign & Emergency Light
INSTALLATION INSTRUCTIONS
Model: ECL310UNVWHG2SD, ECL310UNVWHG2RSD,
ECL310UNVWHR2SD, ECL310UNVWHR2RSD
Tools Needed
A Phillips screwdriver will be needed to install the ECL3.
A drill is needed to remove the knockouts if back
mounting.
Flexible Conduit Only
Figure 1 - Faceplate Removal
Figure 2 - Back Mount