Summary of Contents for Locstar LS-DT301
- Page 1 User Manual for LOCSTAR Lift Controller LS-DT301/311/503/513/-K01/-K02/-K12/-K13 Applicable model: Shenzhen Locstar Technology Co., Ltd. Please read the manual when installation Keep the manual properl y for future ref erence.
-
Page 2: Table Of Contents
电梯控制器用户手册 V2.0 V2.0 User Manual for Lift Controller Table of Contents I. System Overview ........................II. System Composition......................3-4 III. Technical Parameters.......................4 IV. Wiring Instruction for System Installation...............5 V. Lift Control Card-reader Setting....................6 VI. Explanation of Card Authority....................6 VII. Working Procedure........................6 第... -
Page 3: System Overview
V2.0 User Manual for Lift Controller I. System Overview The lift/elevator system security is an important part for a hotel. With Locstar system, all lift-card holders shall be subject to prior authorization from the system administrator. When using the lift, different person will be allocated with different authority, to enter into floors. - Page 4 V2.0 User Manual for Lift Controller LS-DT503/513 lift card reader (For Mifare lock system) Use Mifare S50 card to read information. Which produced by PHILIPS. Fit Locstar Mifare Door lock System or above is employed. Reading distance: less than 5CM Voltage for reader: 12V Working temperature: -10℃～55℃...
- Page 5 电梯控制器用户手册 V2.0 V2.0 User Manual for Lift Controller IV. Wiring diagram instruction 1. Installation To facilitate wiring, the lift controller should be positioned near to the lift control cabinet at the top of lift. Lift control reader, which is mounted on the car,.Lift reader power supply is powered by the lift controller.
- Page 6 电梯控制器用户手册 V2.0 V2.0 User Manual for Lift Controller Wiring Diagram of Lift Controller and lift Remark:for the above lift control and lift wiring diagram,each PCB controls 4 floors. 第 6 页 共 8 页...
-
Page 7: Explanation Of Card Authority
电梯控制器用户手册 V2.0 V2.0 User Manual for Lift Controller V. Lift Reader Setting 1.How to setup Lift Reader Temic system: Step 1:Touch the existed authorization card to reader, blue indicator light will flash one time; Step 2:Touch room setup card to lift reader, the blue indicator light will flash one time; Mifare system: Step 1:Touch the existed authorization card to reader, blue indicator light will flash one time;... -
Page 8: Working Procedure
电梯控制器用户手册 V2.0 V2.0 User Manual for Lift Controller VII. Working Procedure 1. Working procedure for building control mode: 1) After entering the lift, swipe guest card then press the proper button of floor. For example, a guest holds a guest card, after swiping card, can press any floor buttons for enter into;...