Safety And Warning; Remote Control Replacement; Troubleshooting; Correct Disposal - E-MORE TV Lift 650 Operation Manual

ATTENTION!
DO NOT install upside down. (e. g. installation on the ceiling) It will cause damage to the product and TV.

SAFETY AND WARNING!

This product can be used by children age 8 years and older, a persons with reduced physical, sensory or mental capacity as
long as they have been given proper instructions / training on how to use the product in a safe way and understand the haz-
ards involved. Children shall not play with the product.

REMOTE CONTROL REPLACEMENT

After replacing the remote control, matching of the 2 devices is necessary.
matching-process:
1. Deactivate the power of the TV mount.
2. Press and hold the Up key on the remote controller and reactivate the power.
3. After hearing two "di"-sounds, press the Stop key.
4. After hearing two "di"-sounds, press the Down key.
5. Two "di"-sounds can be heard again. The matching is completed and the remote controller is ready to use.

TROUBLESHOOTING

Error Code Possible Cause
E01, E02 Cables are not connected or broken
the weight of the desk exceeds 60/80 kg
E07 Load weight exceeds 60/80 kg
E08 Input voltage lower than required
E09 Input voltage higher than allowed
Control panel is not connected or does not
E10
receive power
RES
Reset is required
Excessive use
HOT

CORRECT DISPOSAL

This sign indicates that this product must not be disposed through regular household waste within the European
Union. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle
it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the
return and collection systems or contact the retailer where the product was purchased. There you can obtain all
information necessary to dispose of this product properly. (WEEE-Reg.-Nr. DE: 52242201)
E-MORE TV LIFT 650 / 1000
How To Correct
Connect cables properly, if problem persists change engine
Remove weight
Remove weight
Improve the input voltage
Lower the input voltage
Wait 1 second for the error code to disappear
If it persists check the connection cables
Hold the "Down"-Button for a while. The mount will lower to the
minimum height.
Do not use for 18 minutes. System will recover automatically.
11