Clas Ohlson WTE-431 Quick Manual

Rechargeable Torch LED
Please read the entire instruction manual before using
the product and save it for future reference. We apologise
for any text or photographic errors and any changes in
technical data. If you have any questions concerning
technical problems please contact our Customer Service
Department..
Safety
• Never charge the torch in flammable environments
or on flammable surfaces.
• Only use rechargeable Ni-MH batteries of size
LR6/AA.
• Only use the included charger or recommended
charger for the torch.
• Never use a defect charger or cable.
• Always disconnect the charger from the electricity
network after charging because the charger's
charging contacts are live.
• Never expose the lamp to moisture or humidity.
• Never carry the lamp and the charger in the charger
cable.
• Never expose the batteries to naked flames or high
temperatures.
• Avoid contact with leaking batteries.
Product Description
Rechargeable torch with 13 strong LEDs.
• Operates on 3x Ni-MH LR6/AA batteries (included).
• Comes with charger for 230 V and holder.
Mounting the wall attachment
3. Connect the AC/DC adaptor's input to
the holder's bottom. Plug the adaptor
into a wall socket.
GREAT BRITAIN For consumer contact, please visit www.clasohlson.
co.uk and click on customer service.
ENGLISH
Art. no. 18-2110/36-3046 model WTE-431
1. Attach the
attachment with the
included screws.
Make sure you
place it close to a
wall socket where
the charger's
AC/DC adaptor can
be connected.
2. Place the torch in the
holder and make sure
the charger contact
(1) fits in the outlet (2)
on the torch.
Inserting batteries
1. Unscrew the battery cover on the bottom of the lamp
and remove the battery holder.
2. Insert 3x rechargeable Ni-MH LR6/AA batteries
(included) in the battery compartment. Place each
battery with its minus pole towards the battery
holder's pole contacts.
Note: Make sure that the battery is correctly aligned.
3. Place the battery holder with the higher pole contact
facing inward of the lamp's handle.
4. Put the battery cover back.
Use
The batteries must be charged before use. Charge the
batteries for 20 hours before use the first time to reach full
capacity ( see chapter charging).
Using the torch
1. The On/Off switch in the torch's handle turns the torch
off and on. Press once to turn on and one more time
to shut off the torch.
2. When the strength of the light decreases it is time to
charge the torch. Shut off the torch and connect it to
the charger (see chapter charging).
Charging
When the charger is connected the torch cannot be turned on.
1. Place the torch in the holder and make sure the
charger contact (1) fits in the outlet (2) on the torch.
2. Connect the AC/DC adaptor's input to the bottom of
the holder. Plug the adaptor into a wall socket.
3. Charging takes approx. 20 hours. The torch can
remain in the holder on maintenance charge after
being fully charged.
For maximum life length the batteries should be emptied
and recharged completely about every 3rd month.
Care and maintenance
Use a soft damp cloth to wipe the product. Never use
solvents or strong detergents.
Disposal
Follow local ordinances when disposing this product. If you
are unsure about the disposal of this product contact your
municipality.
Specifications
Power supply 3 x LR6/AA-batteries
Power supply holder 230 V AC, 50 Hz
Output charger 4.2 V DC, 200 mA
Size 175 x 50 mm