Summary of Contents for FARM-MAXX URC-48
- Page 1 Models URC-48, URC-60, URC-72 and URC-84 Rotary Cutters Operator’s Manual IMPORTANT! Read This Operator’s Manual Carefully and Completely Before Operating the Rotary Cutter!
-
Page 2: Safety Precautions
Please consult your dealer with any questions you may have! No part of this manual shall be reproduced, copied or disseminated by any means, without Unifarm Machinery Corporation’s prior authorization in writing. Unifarm Machinery Corporation reserves the right to make any necessary changes without giving prior notice, in order to optimize the quality and safety features and does not commit itself to updating this manual every time a change is made. -
Page 3: Operation
Chain guards (optional equipment) should be added to the machine when it is used in areas where people, animals, or property may be hit or endangered by thrown objects. The rapidly rotating blades may strike and throw wire, sticks, loose rocks, or trash with considerable force. Even with chain guards, it is recommended that the operator be sure to keep all persons and animals far enough away from the operating area to be completely clear of thrown objects. -
Page 4: Starting For The First Time
INCORRECT! THE ABOVE POSTION MAKES THE BLADE TOO HIGH CAUSING SKIPPING AND UNEVEN CUTTING. IT ALSO ALLOWS THE BLADES TO STRIKE THE GROUND CAUSING THE SLIP CLUTCH TO SLIP EXCESSIVELY AND THE BLADES TO WEAR PREMATURELY. ADJUSTING LEVEL OF CUTTER ON YOUR TRACTOR (cont.) CUTTER TOO LOW IN REAR INCORRECT! THE ABOVE POSTION CAUSES EXCESSIVE WEAR AND TEAR ON THE TAIL WHEEL. - Page 5 PTO, slowly let the rotary cutter run at low speed for a few seconds and gradually increase throttle to operating speed. Watch carefully for signs of excessive vibration or unusual noises. If any are noticed, disengage PTO and cut off the tractor immediately! Wait for all moving parts to come to a complete stop and investigate the cause.
-
Page 6: General Maintenance
Neither manufacturer or the dealer shall be held responsible for loss of use of the machine, loss of time, inconvenience, commercial loss, or consequential damages. In order for your Farm-Maxx Rotary Cutter Model URC-60, URC-72, URC-84, to be covered by our warranty policy, the warranty registration form must be completed and returned within 10 days of purchase date. - Page 7 Wilson, NC 27893 Attn: Warranty Registration OWNER REGISTRATION ************************************************************************************* OWNER’S NAME:___________________________________________________________ STREET ADDRESS:__________________________________________________________ CITY:__________________________________ COUNTY:__________________________ STATE:________________________________ ZIP:_______________________________ PURCHASED FROM:_________________________________________________________ STREET ADDRESS:__________________________________________________________ CITY:____________________________________ COUNTY:_______________________ STATE:___________________________________ ZIP:_____________________________ DATE PURCHASED:_____________________________________ OWNER’S SIGNATURE:_______________________________________________________ OWNER’S NAME (PRINT):_____________________________________________________ DATE: _________________________________________________ MODEL:_____________________________________________________________________ SERIAL NUMBER:____________________________________________________________ *************************************************************************************...