Page 1
BBS/BSS BriteCor AC Direct Surface Mount Installation Manual...
Page 2
Never use a fixture in a two-wire system that is not grounded. • If dimming functionality is included, use only with Litesheet approved dimmers. • Do not use excessive force when manipulating cables and wires.
Page 3
LiteSheet Solutions Preparation 1. Turn off power source. 2. Remove luminaire from packaging. Installation 1. Drill out (4) pilot holes on BriteCor luminaire flange to 3/16” diameter. 2. While holding the BriteCor luminaire to the desired surface, mark the drilled hole locations on the surface.
Page 4
BBS/BSS BriteCor Surface Installation Manual 3. Hold luminaire to the surface, aligning the pilot holes to the installed anchors. Attach the #8 screws to the anchors. 4. Wire the BriteCor luminaire using NEC approved methods. 5. Provide power to the luminaire. Page 4 of 4...