OmniMed 350717 Instruction Sheet

Instruction Sheet
Computer Security Cart #350717 - #350718
1) The basket should contain:
(4) 10-32 x 3/8 Countersunk Head Screws - (4 sets) Dual Lock Mounting Tape (1) Poly Tray - (4)m 4 x12 screws
2) Cut the straps holding the basket to the center column of the cart and remove the basket.
3) Remove and unwrap the Monitor Plate Head Assembly.
4) With a second person, grasp the cart by the base and ring handle, lift it from the carton,
and set it upright on the floor.
5) Place the basket hook into the receiver loop on the column and the poly tray into one
of the quadrants of the ring handle.
6) Use the 4 provided flat head screws to attach the Monitor Plate Head Assembly to the battery housing.
7) Wipe the surface of the Keyboard Tray with isopropyl alcohol.
8) Remove the backing from one side of each of the Dual Lock tape sets. Attach each to an appropriate
location on the bottom of the keyboard.
9) Remove the backing from the other side of the Dual Lock and position the keyboard on the Keyboard Tray.
Press it firmly into place.
10) Remove the four screws that hold the access plate in place.
11) Insert all cables and wires and organize in the cable management housing.
12) Re-install the access plate. Firmly tighten screws in place.
13) Use M4 screws from monitor to secure the monitor to the monitor plate.
Height Adjustment
To raise stand, press down on foot ring. Note: When not in use for a period of time, use both hands
with equal pressure and press down on ring handle slightly while stepping on foot ring. To lower
stand, use both hands with equal pressure and press down on ring handle while stepping on foot ring.
Keyboard Adjustment
Adjust keyboard tray as needed by loosening the knobs provided
0712.AS.OMNI
Mounting Screws
Monitor Plate