Advertisement
Quick Links
OWNER'S MANUAL
4" SUBMERSIBLE PUMP
Model PL-TE-10 – 1/2 HP, 10 GPM
Model PL-TE-20 – 1/2 HP, 20 GPM
4" Submersible pumps are warranted against defects in material and workmanship
for a period of 3 years from the date of original installation, not to exceed 42 months
from the date of manufacture, whichever occurs first. In no event shall Zabel be liable
for any consequential damages or any labor, material, freight or expense required to
replace, correct or reinstall the product. Zabel's liability is limited to repair or replace-
ment of the part. All warranties are void if the product has been improperly modified,
applied or installed, subjected to misuse or abuse. Except as stated herein, there are
no warranties express or implied, including the warranty of merchantability or warranty
of fitness for a specific purpose.
Zabel Environmental Technology
Zabel Environmental Technology™
Installation • Operation
LIMITED WARRANTY
TM
• P.O. Box 1520 • Crestwood, KY 40014
P.O. Box 1520
Crestwood, KY 40014
Z370 (Rev. 5/12/08)
Advertisement
Summary of Contents for Zabel Environmental Technology PL-TE-10
- Page 1 OWNER’S MANUAL 4" SUBMERSIBLE PUMP Model PL-TE-10 – 1/2 HP, 10 GPM Model PL-TE-20 – 1/2 HP, 20 GPM Installation • Operation LIMITED WARRANTY 4” Submersible pumps are warranted against defects in material and workmanship for a period of 3 years from the date of original installation, not to exceed 42 months from the date of manufacture, whichever occurs first.
- Page 2 TABLE OF CONTENTS • If entrained gas or air present in water being pumped reduce the flow and cause cavitation (which can damage the pump). Warranty ...................1 • Pump has been operated with discharge valve closed (severe internal damage will result). Safety Instructions ................2 ELECTRICAL General.....................2...
- Page 3 open. Start pump. Slowly open valve until the desired flow rate is 2. Make sure that the float switches are set so that the pump stops reached. Final setting must be within pump’s recommended oper- before the pump runs dry or breaks suction. If necessary, adjust ating range.
- Page 4 TROUBLESHOOTING GUIDE PROBLEM CHECK CORRECTIVE ACTION Motor will not start but fuses do not blow No voltage. No voltage at disconnect switch. Replace blown fuses or bad cable, reset circuit breakers. Electrical cable bad. Consult licensed electrician or serviceman. Fuses blow or overload protector trips when motor starts Wrong size fuse, Check fuse or circuit breaker size against chart, Page 2.