Advertisement
Quick Links
WireOrLess Controller V3.16
Set the ID to be used and pair to the wireless receiver
Switch off the controller. (Center position of the power switch.)
Select the desired ID on the Carrera receiver.
Keep the crossover button pressed down.
Move the power switch to the right (activation of wireless mode).
Receiver acknowledges programming with "7-segment round trip". Controller ready to start.
When switching on the controller, the number of flashes indicates which ID it is programmed to.
Activating the configuration mode
For configuration, the controller must first be paired with the receiver and the receiver must be
active during configuration. Alternatively the controller can be set to cable mode including the cable
being connected to the powered Control Unit.
Switch off the controller.
Keep the gas control knob completely pressed (full throttle) and the switch button pressed. Hold
both and now switch on the controller via its power button. (In radio mode: switch to the right, in
cable module: switch to the left).
LED lights up.
Release the switch button
Release the trigger
The configuration starts.
The configuration is based on the Speedflow Wireless programming
The controller shows the currently selected configuration by the number of flashes it emits. It
continuously repeats the number of flashes, separated by a pause.
The desired configuration value is selected by briefly pressing the switch button. A short press of the
button selects the next possible value for the configuration.
The selected value is stored by keeping the switch button pressed until the LED flashes quickly,
confirming the storing of the configuration.
Advertisement
Summary of Contents for Frankenslot WireOrLess
- Page 1 WireOrLess Controller V3.16 Set the ID to be used and pair to the wireless receiver Switch off the controller. (Center position of the power switch.) Select the desired ID on the Carrera receiver. Keep the crossover button pressed down. Move the power switch to the right (activation of wireless mode).
- Page 2 After storing, the next configuration option is displayed via the flashing LED. The following configuration options are available. 1. Number of speed steps 1 x flashing - original Carrera 16 speed steps 3 x flashing - Speedflow control 30 speed steps 4 x flashing - Speedflow control 44 speed levels 5 flashes - WOL 44Plus Selection: press briefly.
- Page 3 Turning the trimmer (the knob on the side oft he controller) bends the curve like you can see in the graph. Center position results in a straight line. Continue to the next configuration step. Set trigger position from which the car starts In this configuration step, you can verify the start position of the trigger and set the position you want.
-
Page 4: Resetting To Factory Default Settings
To make driving with these decoders much easier, you can activate a compensation mode in the WireOrLess controller which neutralizes this behavior. All further settings of the power curves, as described above, are of course retained. -
Page 5: Default Values
Afterwards it must be tuned in again to the desired receiver. If you have reset the controller to its default settings, we recommend to configure the start and full throttle trigger point for your controller again for optimal operation. See "Set the trigger position from which the car starts"... - Page 6 Questions How do I find out on which channel my controllers are currently programmed? Just count the slow flashing signals when switching on. The number corresponds to the channel number How do I check the battery condition? In wireless operation, the LED flashes regularly. The LED flashes the more often the battery is depleated.
- Page 7 Carrera is a registered trademark of Stadlbauer Marketing + Vertrieb GmbH in Puch/Salzburg Austria\ frankenslot is a registered trademark of Slotcar-Factory Cadolzburg Germany...