Advertisement
Quick Links
FCC ID: ELY547-47-1013-T
REMOTE CONTROL
The remote control has a range of approximately 50 ft. (15.25m), it does not have to be
pointed at the fireplace and can pass through most obstacles (including walls).
BATTERY INSTALLATION
1.
Depress tab on the battery cover on the side of the remote transmitter and remove
battery cover.
2.
Install 2 AAA batteries into the remote control. (included)
3.
Replace the battery cover.
AC24V INSTALLATION
1. Depress tab on the cover on the back of the remote transmitter and remove the wire
compartment cover.
2. Remove the 2 lead wires from the wire compartment.
3. Connect the wires to the AC24V hard wires.
4. Replace the cover.
Note:
FLAME ON/OFF BUTTON
Press the right
PURIFIRE ON/OFF BUTTON
Press the right
COUNTDOWN TIMER
To set the Countdown timer, press the left
increase by 30 minute decrements or increments. The countdown timer can be set from 30
Owner's Manual
Wall Switch Style RF Controller, 433MHz
MODEL: 47-1013A-T, 47-1013B-T
There is an internal electronic switch to disconnect the AAA Battery
power supply when the AC24V~ hard wire hook up is made.
to turn the Flame ON or press the left
(For 47-1013A-T version only)
to turn the Purifire ON or press the left
(For 47-1013B-T version only)
IC 1492 A-471013T
to turn the Flame OFF.
to turn the Purifire OFF.
or right
buttons to decrease or
1
Advertisement
Summary of Contents for Jeckson Electric 47-1013A-T
- Page 1 Press the right to turn the Flame ON or press the left to turn the Flame OFF. PURIFIRE ON/OFF BUTTON (For 47-1013A-T version only) Press the right to turn the Purifire ON or press the left to turn the Purifire OFF.
- Page 2 minutes to 6 hours. The fireplace will automatically turn OFF when the sleep timer reaches 0 minutes. SET TEMPERATURE Press the left or right direction button together of to select between ° F and ° C. Press the left or right direction button to decrease or to increase temperature.
- Page 3 WARNING Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.