Advertisement
Quick Links
Controller EEL-S4
MANUAL
What is the EEL-S4?
The Bansbach S4 series is a range of battery-based actuator controllers developed especially for mobile
applications. The controller can manage up to 4 actuators with a wired handset and it is supplied by
either a NiMH Li-Ion-battery.
The controller may be configured using PC software which may be ordered separately from Bansbach.
This allows patterns of operation, stroke length, speed, etc. for the connected actuators to be adjusted.
Technical data and model designation:
Input voltage: 24VDC
Operating temperature: 5°C to 40°C
Relative humidity: 20% to 70%
Atmospheric pressure: 1atm
Max. operating attitude: 2000m
Battery technology: NiMH or Li-Ion
Preparation
Before the system may be used, the battery must be charged using the accom-
panying charger. It takes 5-8 hours to fully charge a battery.
The yellow LED lights up when the charger is connected to power. Place the
battery in the charger by sliding it in and rotating it until it is pulled into place by
the magnets. The green LED will flash at approx. 1 second intervals while the
battery is being charged. Once charging is complete the green LED remains
permanently lit. Remove the battery by rotating it 90 degrees. It will then be
ejected and be ready for use.
Once the battery is fully charged, insert it into the controller. Follow the same
procedure as for the charger. If everything is OK, the controller will simply sound a beep (one second)
once the battery is in place. If the system has any faults, the beep will be followed by an error indication
according to table 1 below.
When the battery requires recharging, transfer it to the charger as described above. It is recommended
that you keep an extra battery on hand to avoid disruption to operation.
Always wait at least two seconds after the last actuator has stopped moving before removing the battery.
Otherwise the controller may not have time to store the position and it may be necessary to perform
0-point calibration as described in section „Normal operation".
EEL-S4
Battery Based Actuator Control System
Advertisement
Summary of Contents for Bansbach Easylift S4 Series
- Page 1 Battery Based Actuator Control System What is the EEL-S4? The Bansbach S4 series is a range of battery-based actuator controllers developed especially for mobile applications. The controller can manage up to 4 actuators with a wired handset and it is supplied by either a NiMH Li-Ion-battery.
- Page 2 Battery, controller and remote control. Battery mounted in the controller – ready for use Normal operation During normal operation the actuator is driven in an out using the appropriate buttons on the remote control. Situations may arise which require a particular action. These situations are described below. 1.
- Page 3 S4 controller’s status indications: Name Description Conditions Buzzer Red LED Green Handset Comments Startup Confirm Battery voltage 1 med 1 med 1 med 1 med battery OK >Level3 Low Battery Shutdown Battery voltage Shutdown <Level1 operation Low Battery Min. level Battery Voltage 3 short 3 short...
- Page 4 If the actuators cannot be operated, perform a 0-point calibration as explained in section If none of the above resolves the problem, please contact the supplier. The flyer is subject to technical alterations and printing Bansbach easylift GmbH Tel. +49 (0) 7172/9107-0 info@bansbach.de Barbarossastraße 8...