Advertisement
Quick Links
Thank you for purchasing a Flite™ induction heater! Flite packs a lot of functionality into its
small size. This is an overview of the most important info.
18350 Battery Requirements:
• 3x matching 18350 batteries
• Flat top
• Unprotected/high discharge (CDR >= 9A)
• 1100+ mAh capacity recommended. 900 mAh is serviceable, less than 900 mAh capacity
not recommended
Flite has an on-board battery management system that includes balanced charging, low voltage
cut off, reverse polarity protection, and over voltage protection.
Battery Charging in Unit:
To charge the Flite's batteries in place, attach a 12.6VDC charging adapter (2.1mm x 5.5mm
center positive tip) to the Flite's DC port.
Suggested charge rate: 12.6VDC@1A. Charge status is managed by the charging adapter.
To use the Flite:
1. Slide Flite's power switch to Pulse or Full, as desired. Pulse/PWM operation is explained
below.
2. Insert the Dynavap into the coil and either press the cap to the two contacts to activate
the heater, or press the push button on the side if present. If pressing the cap against
the switch contacts, press lightly to moderately; do not grind or use excessive force!
3. Remove when the Dynavap clicks, or to taste.
Cap-as-Switch™ suggestions for best results:
• Press lightly to moderately to activate; do not grind the cap against the contacts or use
excessive force!
• If you're having trouble making a good connection, rotate the cap a few degrees and try
again. When you do make a good connection, note the position of the digger so you can
return the cap to this spot in the future.
• Clean caps connect better. Use isopropyl alcohol to clean the end of your cap.
NOTE: The cap-as-switch feature is new to the Flite. If you decide you don't like it, Fluxer
Heaters will be glad to convert your cap-as-switch heater to a push button heater for the
cost of postage. Email
Flite Quick Start Guide
V1.0
Flite 3S 18350 Powered Induction Heater
Quick Start Guide
fluxerheaters@gmail.com
for more info.
©Fluxer Heaters LLC, 2020
https://www.fluxerheaters.com
Advertisement
Summary of Contents for Fluxer Heaters Flite 3S
- Page 1 Flite 3S 18350 Powered Induction Heater Quick Start Guide Thank you for purchasing a Flite™ induction heater! Flite packs a lot of functionality into its small size. This is an overview of the most important info. 18350 Battery Requirements: • 3x matching 18350 batteries •...
- Page 2 The longer, slower heating time typically produces more vapor and/or more flavor, depending on how one sets the trim wheel. Other factors such as your tip material and your batteries’ charge status will also affect PWM results. Flite Quick Start Guide ©Fluxer Heaters LLC, 2020 V1.0 https://www.fluxerheaters.com...
- Page 3 ONLY! DO NOT use a mains-powered PSU as the more efficient power supply may damage the Flite!!!!! The Flite’s very small circuit doesn’t have the necessary capacitance to meet the power demands of a mains-powered PSU! Flite Quick Start Guide ©Fluxer Heaters LLC, 2020 V1.0 https://www.fluxerheaters.com...
- Page 4 Warranty: Your Flite includes a 12 month warranty on parts and labor. Please contact fluxerheaters@gmail.com with issues and/or questions. Thank you for purchasing a Flite portable induction heater from Fluxer Heaters! I hope it brings you much enjoyment! Nothing fluxes like a Fluxer!™...