Download Print this page

FOGE VL-TNL Series Instruction Manual

Tunnel light

Advertisement

Quick Links

P1
Instruction Manual
Product: VL-TNL Series
Tunnel Light
www.fogegmbh.com
info@fogegmbh.com
FÖGE ELEKTRONIK GMBH
Böhleswasenweg 11
72555 Metzingen
+49 7123 9570508
Ver. 20.3.001

Advertisement

loading

Summary of Contents for FOGE VL-TNL Series

  • Page 1 FÖGE ELEKTRONIK GMBH Böhleswasenweg 11 72555 Metzingen +49 7123 9570508 Instruction Manual Product: VL-TNL Series Tunnel Light Ver. 20.3.001...
  • Page 2: Intended Use

    1. Intended Use VL-TNL Series Tunnel Light is designed for use in industrial areas. Purpose of the product is inspection of parts, positioning, color check, code reading, quality inspection. Light is positioned above the part. The system must be operated within the limits specified in technical data and used according to technical specifications as well as installation instructions.
  • Page 3: Dimensions / Installation

    3. Dimensions / Installation System operation assumes knowledge of the assembly instructions. The symbols used for safety is shown in section 8(Safety) of manual. Camera VL-TNL Part Accessories Suitable Product Ordering Code Accessories Image VL-TNL-37-70-R-24-C30 VL-TNL-BR-01 VL-TNL-37-70-W-24-C30 VL-TNL-37-70-R-24-C30 VL-TNL-BR-02 VL-TNL-37-70-W-24-C30 Solar panel inspection, large Shiny surface inspection Part mark read with diffuse...
  • Page 4: Electrical Connection

    4.Electrical Connection 5. Display/Controls Light Light ON Position Percentage Accessories Image Intensity Illumination ON : % 100 Can be used without strobe, continuous OFF : % 0 (Standard High Intensity) illumination mode intensity Due to high illumination settings, use modes with ON : % 85 this mode only with strobe input with given OFF : % 15...
  • Page 5 6. Faults In any case do not open the product. If the leds not on check the connection and power supply. If still leds are not on contact FÖGE or distributor. 7. Warnings • Connect the power supply and the display/output device according to the safety regulations for electrical equipment.
  • Page 6: Liability For Material Defects

    8. Safety System operation assumes knowledge of the assembly instructions. The following symbols are used in these assembly instructions: Indicates a hazardous situation which, if not avoided, may result in minor or moderate injury. Indicates a situation that may result in property damage if not avoided.

This manual is also suitable for:

Vl-tnl-37-70-r-24-c30Vl-tnl-37-70-w-24-c30Vl-tnl-200-250-r-24-c30Vl-tnl-200-250-w-24-c30Vl-tnl-200-500-r-24-c30Vl-tnl-200-500-w-24-c30 ... Show all