JackJaw 301 Assembly And Operating Instructions

JackJaw ® 301/302 Assembly and Operating Instructions
Step 1: Place contents of
box on fl oor or table. Place
handle over riser tube with
decal facing up and insert
short 3/8" - 24 bolt.
Basic Tent Stake Pulling
Step 1: Lift handle to up position so that jaws are fully open.
Step 2: Place unit so that jaws are on either side of the stake.
Figure 1 and 2 below.
Step 3: Place foot on base. Figure 3 below. Push down
on handle, clamping on stake and lifting it out of the ground.
Step 4: Repeat motion as necessary until stake is free.
1.
Tip: In soft conditions or mud, place a short piece (1 to 2 feet in length) of 2 x 6 lumber under the base of the unit. This will
spread the force over a larger area, allowing stake removal even in muddy conditions.
Caution:
Replacement Jaw Set - 4 jaws & hardware Part # CA0003
Assembly Instructions
Step 2: Start 3/8"-24
self locking nut on to
bolt.
Operating Instructions
2.
Never put your fi ngers or hands between the jaws, or between the jaws and the stake.
Construction Accessories, Inc. • Phone 937-429-9089 • Fax 937-427-4653
email: warranty@constructionaccessories.com • www.jackjaw.com
Printed in U.S.A. • Product Made in the U.S.A.
Step 3: Swing link arms up to
handle. Insert the long 3/8"-
24 bolt through link arms and
handle. Install fl at washer on
bolt. Start 3/8"-24 locking nut
on bolt.
Tilted Tent Stake Removal
Step 1: When you pull a tilted or
leaning stake, simply put the unit on
the high side and lean the stake puller
over so that the shaft aligns wih the
shaft of the stake. If the ground is un-
even, use two blocks of wood to level
the base of the stake puller so that the
central shaft is parallel to the stake.
Figure 4.
3.
Step 2-4: Same as Basic Tent Stake
Pulling Stakes from Asphalt
JackJaw stake pullers excel on asphalt. When pulling from
asphalt, make sure that the stake puller is aligned with the
direction of the stake. This keeps the stake from binding with
the asphalt. The stake will usually come straight out. If you
have some diffi culty, try moving the puller around the stake to
get better alignment.
Step 4: Use two 9/16" wrenches
to tighten riser bolts and nuts and
link arms onto handle.
Note: Nut will stop before con-
tacting the handle. Then, back off
the nut on the link arm bolt one
half turn from the washer. Handle
should raise and lower freely.
Completed
Assembly
4.
March 2011