Summary of Contents for Karlu Photographic KarLite KARSB60
Page 1
Karlu Photographic Square Softbox Assembly Instructions KARSB60/KARSB90/KARSB100/KARSB120 1. The Softbox Kit. Unpack and identify the items in your softbox kit: Speedring Assembly (Qty 1). Rods (Qty 4). Karlite Carry Bag (Qty 1). Inner Diffuser (Shown here on top of carry bag).
Page 2
Refer to the previous images on page 1 of this guide figure 1, figure 2 and figure 3. Figure 1 shows the S Type Speedring with the lugs that are used to secure the softbox to any compatible S Type flash head.
Page 3
When you have done this place the rod holders in their normal positions (see figure 3 if you are not sure). Your softbox will now look more like a softbox and should be rigid (see figure 7) below with the four rods connected to the speedring and the corners of the softbox and each passing over a Velcro strip (this Velcro strip is used to help fix the inner diffuser panel).
Page 4
That’s the softbox finished and you can now attach it to any S Type flash head. Please note though that unless you have a specific softbox with heat vents DO NOT connect your softbox to a tungsten or halogen (i.e. hot lights) light head as this may cause overheating and damage to equipment as well as being a fire hazard.