ONVU Oncam Evolution 180 Outdoor Quick Start Manual

Option A. Surface Mounting
1.1
Prepare the bracket for surface mounting
1.3
Route a cable through bracket
Completing the Installation
p if the camera
2.1
Remove the rear enclosure
2.3
Hook in rear enclosure and set mount angle
Package Contents
Camera components
• Remove the back cover by
unscrewing the M20 plug
and M32 to M20 adapter.
• Refit them into the unused
port on the top.
• Route an unterminated
network cable through the
bracket. Leave a minimum of
60cm of cable protruding.
• M12 Conduit ports are
available for side cable entry
via the M12 to M20 adapter
(J).
• Remove the sun shields.
• Undo the locking screw
(turning it anti-clockwise).
• Remove the front cover but
leave the protective film on
the dome.
• Unscrew the 4 security
screws.
• Loosen the pivot screws from
the outside.
• Hook the rear enclosure on
the mounting bracket.
• Pull the rear enclosure down
fully.
• Terminate the cable with a
RJ45.
• Aim the rear enclosure at the
required angle for the camera
• If camera is tilted, remove
infil (P).
• Tighten the pivot screws and
then the locking grub screws.
J. M12 to M20 adapter
K. M32 Conduit Locking nut
Accessories
• Drill mounting holes.
• Drill hole for cable entry within
the shaded areas.
1.2
Drill holes
Option B. Pendant Mounting
1.1
Mount bracket on pendant
2.2
Route cable into rear enclosure
• Insert the SD card into the camera module (optional).
• Plug the RJ45 into the camera module.
• Tighten up 4 security screws that fix the camera module to the rear enclosure.
• Take off the protective plastic film off the dome.
• With care, replace the front cover and tighten up the locking screw.
• Replace the sun shields.
• Both camera LEDs should be green when the camera is booted with an ethernet
connection.
Note:
For 12V power supply installation, please refer to the User manual for more information.
2.4
Connect and fix camera module in enclosure
Supplied Parts
• A. Front Cover
• B. EVO-180 Camera module
• C. Rear Enclosure
• D. Mounting Bracket
• E. Back cover
• F. Sun-shields x 2
• G. Side Conduit plug x 2 (fitted)
• H. M32 - M20 Adapter (fitted)
The Evolution 180 Outdoor camera is designed for installation on flat surfaces or
pendants. The camera is supplied with a mount bracket that is used to fix the camera to
a surface or a pendant.
Note:
You will need 4 appropriate fixing screws for surface mounting.
• Route an unterminated
network cable through the
pendant mount hole.
• Screw the mount assembly
onto the pendant and lock
with the locking nut (K).
• Leave a minimum of 30cm of
ethernet cable protruding.
• Pass the network cable
through the P-clip and cable
gland.
• Pull 30cm of cable through
and then tighten the nut fully
as shown.
• Insert "Infil"(P) only if
the camera is to be set
horizontal. If the camera is
to be tilted, the infil is not
necessary.
• I. M20 Conduit Port plug (fitted)
• J. M12 - M20 Adapter
• K. M32 Conduit Locking Nut
• L. Drilling template
• M. Screwdriver and security bit
• N. 12 pin I/O 12V Connector
• O. Quick Start Guide
• P. Infil black cover (fitted)
• Q. Reverse mount screws