JALEXANDER JAE318 Assembly Instructions

MODEL #: JAE318
JAE318-T20 (INTEGRATED LED)
TABLE LAMP
IMPORTANT SAFETY INSTRUCTIONS
Read and Save:
1. Do not use the lamp in high-temperature or high humidity
environments. This product is NOT waterproof.
Do not disassemble the product. Altering or modifying the
2.
lamp in any way will render the product unsafe.
3. To prevent bad connections, avoid pulling wiring
connections when removing contents from package
or during installation.
4. This lamp is approved for indoor use only. Do not keep
close to windows or direct sunlight.
5. Unplug the lamp fixture if it is not being used for extended
periods of time.
6. This lamp has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment on and off, the user is encouraged to
try to correct the interference by one or more of the following:
Reorient or relocate the receiving antenna.
Increase the separation between the lighting unit and receiver.
Connect the lighting unit into an outlet on a circuit other than
the outlet which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
assistance.
7. The lamp fixture is not designed to support, additional
weight. Do not hang any object from any part of lamp.
8. Do not look at the LED light source directly.
ASSEMBLY INSTRUCTIONS
1. Place the base on a flat surface.
2. Insert the plug into an electrical outlet.
3. Use the 3 way touch switch on the base to adjust the
brightness to meet your needs. Touch Switch with Three
Step Dimming Low, Medium, High, and Off.
BULB REPLACEMENT
Integrated LED bulb replacement not required.
CLEANING AND MAINTENANCE
1. To clean: use a soft, dry cloth only.
2. Do not use chemical or abrasive cleaning solutions.
For Customer Assistance:
www.jalexanderhome.com
Made in China
3 way touch
switch