HOFFLIGHTS ATHENS Instructions

IRH001.01
INSTRUCTION FOR LIGHT SOURCE/CONTROL GEAR
Applied to product family and references:
ATHENS 2.4011.1112 | 2.4011.1312 | 2.4012.1112 | 2.4012.1312 | 2.4013.1112 | 2.4013.1312
2.3501.1112 | 2.3501.1312 | 2.3502.1112 | 2.3502.1312 | 2.3513.1112 | 2.3513.1312
2.3511.1112 | 2.3511.1312 | 2.3512.1112 | 2.3512.1312
ZAMBIA 2.3065.1112 | 2.3065.1312
Replacement instruction intended for a professional.
In case of doubt contact us.
Attention: Before doing any works, switch off power of the mains supply or respectively of the connection lead and
follow our safety precautions given in the product installation manual included in the product packaging.
- Read with care the installation manual according to product family included in the containing product.
- Uninstall the product in the reverse established order in the installation manual.
- Make sure that the product is place on a stable, even and safe environment.
- Use appropriate tools until reach the light source like shown in pictures.
- The light source is assembled by screws, unscrew them to take it out.
- Collect all the removed parts of the replacement for a following reassembly.
Pictures (as an example, the current situation may differ)
- Once reached the light source, desolder the positive and negative cables from circuit.
- In case a control gear replacement is needed (see above pictures), disconnect the control gear connection cables
from terminal block and take it out unscrewing it or pry it from supporting element with a flat tool. The positive
and negative cables could be removed (as applicable) either desoldering from LED module, unscrewing them from
control gear or cutting them (leave enough space to solder them again when reassembly).
- By cooling reasons, a heat sink compound is needed between LED module and metal base. Please, be sure that the
heat sink compound cover completely the LED module surface.
- In order to assemble again the product, proceed in the reverse order of this replacement instruction.