Page 1
CAMSAT WIRELESS VIDEO KIT (VT1, 2) INTRODUCTION The CAMSAT range of video transmitter receivers are designed for wireless PAL or NTSC video signal transmission over the radio-link on the ISM 5.8 GHz band. They support 8 channel settings within the range 5725 to 5875 MHz, each setting using an individual channel to avoid interference when using multiple video/sender receivers.
Page 2
SETTING UP It is recommended that you configure the devices and test the operation before positioning and mounting. CHANNEL SETTINGS The Transmitter/Receiver kit will only support 1 channel at a time, however you can use separate channels to allow the use of multiple devices. ...
Page 3
VT Receiver VT Transmitter Plastic cover Antennae Antennae Plastic cover The VT1 allows for connecting the Video signal to an RG59 plug, however this can obstruct the cover without an elbow joint. You can connect the video using the Vid + and Gnd Vid/Aud on the connector block. This RG59 can be used to connect a test monitor on the receiver module.