Owners Manual
INTRODUCTION
PLEASE READ THIS SAFETY INFORMATION CAREFULLY BEFORE USE.
Read and retain this instruction manual to assist you in the operation of your new product.
Failure to follow all instructions listed below may result in electric shock, fire, serious injury and/or
damage to the power tool. The term "power tool" in all of the warnings listed refers to your battery
operated (cordless) power tool.
WARNING
Only use genuine Macnaught Battery and Charger on Macnaught battery operated power tools.
Battery P/N - PGB
Battery P/N - PGB-3A
Battery P/N - BPB-20AH
Charger P/N - BPC-A (Australia) / BPC-U (USA) / BPC-B (UK) / BPC-E (Europe)
Charger P/N - PGC (for 2A)
Charger P/N - PGC-3A (for 3A)
GENERAL SAFETY
DO NOT operate power tools in explosive areas, e.g; close to flammable liquids, gases or dust.
ELECTRICAL SAFETY
Never modify electrical connections.
•
DO NOT expose or use battery or charger in rain or wet conditions.
•
DO NOT use product if the product is damaged.
•
Only use "ORIGINAL" Macnaught replacement parts, battery or charger.
•
BATTERY and CHARGER SAFETY
DO NOT place any object on top of the charger or place the charger on an uneven surface.
•
If "Charger" case is damaged DO NOT use - danger of electric shock or electrocution.
•
Battery charger MUST ONLY be used for charging Macnaught rechargeable batteries.
•
DO NOT operate charger if charger, power cord or plug is damaged - replace immediately.
•
When removing charger from wall outlet, turn off power point, remove by pulling plug only (not cord).
•
DO NOT disassemble charger or battery for any reason.
•
DO NOT store or use the charger and battery pack in locations where the temperature may reach or
•
exceed 40°C/104°F.
BP20-BC-inst-issue1
BATTERY and CHARGER
1