Advertisement
Quick Links
We open up New Horizons
`
1
Description
2
Technical Specifications
Dimensions
Weight
Material
Transmitter Frequency
Certification
3
Installation
1 1 1 1
Mounting the pushplate:
LOCKING TAB
MOUNTING
KEYS
DOUBLE
GANG MOUNTING
HOLES
(TOP AND BOTTOM)
The Panther pushplate may be mounted with or without the mounting
bracket. To use the mounting bracket, screw a minimum of two (2)
screws into a solid surface through the holes in the mounting plate (#8
countersunk head screws must be used). The mounting plate must be
mounted so that the text side is facing up.
75.5172.03 20060608
Hex Key
Housing Assembly
Faceplate Assembly
10EMR61 SHOWN
: 6 ¼" (160mm) Dia. x 1.5" (36mm) H
: 1.2 lbs (0.54 kg)
: ABS Plastic and Stainless Steel
: 433 MHz
: FCC
To attach the housing to the mounting plate, place the housing over the
key tabs on the mounting plate, and then slide the plate downward until
the locking tab engages the housing. To remove the housing, press in
the locking tab and reverse this procedure.
NOTE: To securely lock the plate, put an additional screw through both
the housing and the mounting plate.
PANTHER SERIES
PANTHER SERIES
PANTHER SERIES
PANTHER SERIES
USER GUIDE
ENGAGE KEYS
LOCK/
UNLOCK
1/2
Advertisement
Summary of Contents for Halma BEA PANTHER Series
- Page 1 PANTHER SERIES PANTHER SERIES PANTHER SERIES PANTHER SERIES USER GUIDE We open up New Horizons Description Hex Key Housing Assembly Faceplate Assembly 10EMR61 SHOWN Technical Specifications Dimensions : 6 ¼” (160mm) Dia. x 1.5” (36mm) H Weight : 1.2 lbs (0.54 kg) Material : ABS Plastic and Stainless Steel Transmitter Frequency...
- Page 2 Function: PRESS (TOP AND THEN BOTTOM) DETACH/ REATTACH (LISTEN FOR CLICK) BATTERY LOCATION (OBSERVE PROPER POLARITY) To assemble or disassemble the pushplate, use the enclosed hex key (or To replace the battery, remove the faceplate and the four (4) screws similar diameter tool) to press in and release the spring clips from the holding the battery cover to expose the transmitter assembly.
- Page 3 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules.