Download Print this page
Vecima 66 H Series Installation Manual

Vecima 66 H Series Installation Manual

Advertisement

Quick Links

Vehicle Productivity, Security, and ELD Compliance
The 66xxH family of beacons includes the following models:
6600H – 3G with external antenna
6601H – 3G with internal antenna
6650H – 4G (LTE) with external antenna
6651H – 4G (LTE) with internal antenna
These versatile GPS tracking beacons are designed for fleet management needs in
all commercial vehicles. The "H" designation in the model number is used to indicate
beacons that are hard wired when installed in the vehicle.
Combined with our commercial mobile monitoring portal, subscribers can manage
and view the location of any or all vehicles in a fleet, run a variety of valuable reports,
and manage vehicle maintenance alerts.
Kit Contents
• GPS Beacon device with SIM
• Combined GPS/Cell Network antenna (if
required)
• Wiring harness
Antenna Configuration
The 66xxH beacons have a combined GPS/cell network
antenna module. The 6600H and 6650H models use an
external antenna attached with FAKRA connectors, while
the 6601H and 6651H are equipped with an internal
antenna housed within the beacon.
For either configuration, the antenna must be positioned
in the vehicle so that it has a clear signal path to as much
of the sky as possible, without metal obstruction. For
internal antennas, the beacon itself must be positioned
properly for good signal reception.
External Antenna Installation (6600H and 6650H only)
The following antenna models are supported:
Standard Antenna
Part Number: 6xx0-ANT-STD
Black plastic housing; approx. 2.5 in (64 mm) diameter;
0.4 in (10 mm) depth
Mounted with peel-and-stick adhesive patch
rev 2020.04.17
Page 1 of 6
Vecima 66xxH Beacon Family
Tools and Supplies Required
• Wire cutters, wire strippers
• Voltmeter (multimeter)
• Soldering iron, solder
• Electrical tape
Weatherproof Drill-through Antenna
Part Number: 6xx0-ANT-WPA-DT
Black plastic housing with rubber weather-seal;
approx. 2.5 in (64 mm) diameter; 0.7 in (18 mm) depth
(excluding screw post)
Screw post mount for drill-through applications
installation guide
• Plastic cable ties
• Screw drivers, mounting screws
• Wrenches, sockets
© 2020 Vecima Networks Inc. All rights reserved.
www.vecima.com

Advertisement

loading

Summary of Contents for Vecima 66 H Series

  • Page 1 2.5 in (64 mm) diameter; 0.7 in (18 mm) depth (excluding screw post) • Mounted with peel-and-stick adhesive patch • Screw post mount for drill-through applications rev 2020.04.17 www.vecima.com Page 1 of 6 © 2020 Vecima Networks Inc. All rights reserved.
  • Page 2 These models are ideally located under the dashboard, and the same guidelines for installing an external antenna (described above) are applicable. • Visibility of the indicator LEDs will be useful for testing and troubleshooting. rev 2020.04.17 www.vecima.com © 2020 Vecima Networks Inc. All rights reserved. Page 2 of 6...
  • Page 3: Important Notices

    Failure to install the ignition sense correctly will result in erroneous data being reported from the beacon. This may result in false or incorrect reporting of vehicle starts, stops, ignition on and off. rev 2020.04.17 www.vecima.com © 2020 Vecima Networks Inc. All rights reserved. Page 3 of 6...
  • Page 4 When using auxiliary inputs to measure the state of vehicle circuits, it is recommended that you use a relay to control the input signal to the device. rev 2020.04.17 www.vecima.com © 2020 Vecima Networks Inc. All rights reserved. Page 4 of 6...
  • Page 5 If a suitable panel for affixing the beacon is not available, fastening the beacon to a bracket or wire bundle with plastic cable ties is also adequate. Be sure to secure any loose or extra lengths of wire. rev 2020.04.17 www.vecima.com © 2020 Vecima Networks Inc. All rights reserved. Page 5 of 6...
  • Page 6: Led Indicators

    Modem module fault. Please contact Vecima Support. No SIM inserted. Please contact Vecima Support. No cellular signal. Network not found. Please contact Vecima Support to verify the SIM activation. Last data session failed. GPRS not attached. Please verify beacon activation.

This manual is also suitable for:

6600h6601h6650h6651h