Advertisement
Quick Links
QLSWH
Counterclockwise Clamping
Bottom
SWING CLAMPS (Heavy)
Body/Cam/Handle
SCM440 steel
Quenched and tempered
Black oxide finish
Clamping End
Throw
Clamp Starting Position
４-M
Clamp that works in two steps :
adjusting clamping position with the adjustment knob,
and tightening the clamp arm with the handle
Clamp Arm/Holder/
Bolt
Handle Shank
SCM435 steel
S45C steel
Quenched and tempered
Quenched and tempered
Black oxide finish
Black oxide finish
Clockwise Clamping
Clamp Starting Position
M
1
Adjustment Knob
S45C steel
Black oxide finish
L
L
1
3
L
2
Clamping End
D
1
Adjustment Knob
W
2
D
Handle
Phenolic plastic
Black
Throw
Advertisement
Related Manuals for IMAO QLSWH Series
Summary of Contents for IMAO QLSWH Series
- Page 1 QLSWH SWING CLAMPS (Heavy) Clamp that works in two steps : adjusting clamping position with the adjustment knob, and tightening the clamp arm with the handle Clamp Arm/Holder/ Body/Cam/Handle Bolt Adjustment Knob Handle Handle Shank SCM440 steel SCM435 steel S45C steel S45C steel Phenolic plastic Quenched and tempered...
- Page 2 Countersink The handle can be removed by Locking Screw loosening the locking screw. To keep the handle mounted permanently, make sure that the locking screw is fully tightened. When Handle Is Removed Clamping Clamping Part Number Dp H Direction Stroke Clamping Height QLSWH400R 70～80...
- Page 3 Application Example Contact Bolt BJ７３２ Clockwise Clamping Clockwise Clamping (Handle at Clamping End) (Handle at Clamping End) Custom Riser Technical Information Performance Curve ■Allowable Loads in Machining of Workpiece Bottom QLSWH500R , L Workpiece F max. QLSWH400R , L Fixture Plate Operating Load (N) Type Allowable Force To Workpiece Bottom (Per Clamp)
- Page 4 ■Custom Clamp Arm Recommended Dimensions Type (Max.) (F8) (±0.1) QLSWH400 M6 × 1.00 QLSWH500 M8 × 1.25 ■Clamp Arm Installation / Removal To install a clamp arm, 1. Place the wave washer on the shoulder of the bolt and then fit the clamp arm onto the bolt. 2.