AquaScape 230222 Installation Instructions

60-Watt Transformer
Installation Instructions
Package Includes:
• 60-Watt Transformer
• Instructions for Use
LISTeD
e181950
5G45
Features
• Photocell timer automatically turns power on
and off at dusk
Instructions
1) To connect low voltage cable, split one end of cable
approximately 2" and strip about 1/2" of insulation
off each wire (diagram 1). Insert wire under termi-
nal as shown (diagram 2). Tighten screw securely.
2) Hang transformer from a secure object such as
a post or the side of your home (diagram 3).
3) Plug transformer into a GFCI outdoor electrical
outlet that has a weather-resistant cover, do not
use extension cord.
4) Route low voltage cable to desired fixture locations.
Hook up fixtures to LVL cable. cauTIOn: Fixture(s)
must be installed in accordance with all local codes
and ordinances. Turn power pack to "AUTO" and
cover photocell for 30-60 seconds to test. Hide or
bury cable as desired only AFTeR entire installation
is completed and lighting effect is achieved.
Setting Timer
8H auTO
D
6H 4H
C B
Troubleshooting
1) Make sure transformer is plugged in. Is outlet working?
2) Caution: If circuit breaker trips when the transformer is turned on – Unplug the transformer from
the AC outlet. Correct fault. Reset the circuit breaker and plug transformer back in.
3) Is lamp burned out? Use another lamp to test.
4) To maximize the life of the transformer and lights. The transformer should only be operated at 80%
of its total wattage (ie. 80% of 60 watts = 48 watts).
Item #99070.032008
• Set desired on time in 4, 6 and 8 hour intervals
diagram 1
auTO - turns unit on at dusk/
A
off at dawn
A
4 H - turns unit on at dusk/
B
off after 4 hours
6 H - turns unit on at dusk/
C
off after 6 hours
8 H - turns unit on at dusk/
D
off after 8 hours
©2008 Aquascape, Inc. • All Worldwide Rights Reserved
WaRnIng
This product should be grounded. In the event of an electrical short circuit, grounding reduces
the risk of electrical shock by providing an escape wire with an appropriate grounding plug.
1) Do not repair, or tamper with, this cord or plug.
2) Do not use extension cords.
3) Do not submerge transformer.
4) Do not connect two or more power supplies in parallel.
5) Do not use with a dimmer.
Fixture(s) must be installed in accordance with all local codes and ordinances! For use with
low voltage outdoor landscape lighting systems and LGPC submersible fixtures. Not for use
with pool/spa equipment.
dIsclaIMeR
This lighting system is designed to last for many years under normal conditions. However, lamps
eventually burn out and losing one can shorten the life of the others. Conditions beyond control
(high input voltage, poor voltage regulation, etc.) will also affect lamp life. It is, therefore,
important to replace a burned out lamp promptly.
diagram 2
1/2"
(1.27 cm)
Terminal
Screw
Pressure
Plate
Make sure wire
2"
insulation
(5 cm)
clears plate
Finished Wiring
diagram 3
60-W
Transformer
note: Fixtures must be
installed at least 10 ft.
from power pack
12" (39.5 cm)
off ground
Covered
To fixtures >
Receptacle
Also Consider...
Microspot light
™
• Powerful 20 watt
low voltage light
with 15 ft. cord
• Comes with 5
interchangable
lenses (clear, blue,
green, red, amber)
• Includes adjustable
light stand
Item #02407
LED Bullet Spotight
• Professional heavy-duty
brass housing
• energy efficient, only
consumes 4 watts
• Can be used in or out of water
• Small compact design
virtually disappears into
it's surroundings
• Comes with 2 different
mounting platforms,
adjustable stand
or stake
Item #98283
10-Watt Waterfall Light
• Small, halogen light
ideal for highlighting
waterfalls.
• Flat base, so it is easy
to place and hide under
a waterfall
• Light may be used
in or out of water
• 15 foot cord length
• Small compact size:
measures 1 1/2" dia.
7/8" height
Item #99383
Made in China for
Aquascape, Inc.
St. Charles, IL 60174 • Brampton, ON L6T 5V7
www.aquascapeinc.com
IDD 08036205-ADI 080047