Table of Contents
Advertisement
Advertisement
Table of Contents
Summary of Contents for Homemaker HBF110G
- Page 2 Cautions Cautions Disposal of your old appliance To avoid the risk of child entrapment, please make sure your old refrigerator is inoperative and safe by removing the doors and cutting off the power cord before disposal. Refrigeration systems depleting substances, specialized disposal.
- Page 3 Cautions • Warning: For the purpose of safety, the appliance must be properly grounded in accordance with specifications Always remember to unplug the appliance before cleaning. Never unplug your chiller by pulling on the power cord. Always grip the plug firmly and pull it straight out from the outlet.
- Page 4 Parts 1. Evaporator 2. Shelves The manufacturer reserves the right to improve the product from time to time without prior notice.
- Page 5 Observations • Install the appliance in a well-ventilated room. Allow 10cm on each side and 10cm over the top of the chiller for easy installation and proper air circulation. • Do not expose the appliance to direct sunlight or a heat source such as a stove, radiator or heater etc.
- Page 6 Basic Operation The appliance must stand on a flat even surface. If the appliance is to be placed on a carpet, support the appliance on a solid wooden board. If the appliance is placed directly on carpet, compressor may cause color fading of the carpet.
- Page 7 Operating Instructions • Do not store frozen foods and ice cream in the bar chiller - it will thaw! • Wrap or cover food well before storing to avoid odours and loss of moisture content. • The appliance can not be used to store medicine or scientific specimens.
- Page 8 To clean the door seal, use mild, soapy water only. Moving the refrigerator • Unplug the appliance • Remove the contents and empty the water tray on the compressor before moving the bar chiller.
- Page 9 Troubleshooting Before calling the service centre, check the following points and see if you can solve the problem yourself. Problem No refrigeration The inner Temperature is not cold enough. Unusual noises The outer surfaces are wet. The inner surfaces are wet. Possible Causes - The chiller is not plugged in or switched on.