CasaTunes™ CT-2i and CT-3 Music System Quick Start Guide
Hardware Installation
1. For each room, plug one of the included audio cables between the Music System and your amplifier or AV
Receiver line input, if you are feeding a Home Theater. For the CT-2i, only use the Blue and Green connectors
on the Music System (Connectors in green box, above).
2. For the CT-2i, plug the pre-amp output (sometimes called line output) of your analog audio component into
the Pink connector, outlined in the green box, above (available only on CT-2i).
3. Plug a Network cable into the Music System (in jack with blue "Ethernet" label, above). Plug the other end
into your local area network (LAN), with connectivity to the internet.
4. If you are using CasaTunes Keypads, plug your Keypad Hub(s) into the USB connectors (in red box, above).
5. Plug the power supply into the jack on the left side (looking from front) of the chassis .
6. Start your Music System by tapping on the power button on the front. (Note: all audio cables must be
plugged into the Music System's audio jacks before starting the computer!)
7. See other side of this sheet for instructions on setting up the Music System.
CasaTunes
409 Mason Court, Ste. 123
Fort Collins, CO 80524
www.CasaTunes.com
Quick Start
Version: 1.3
Date:
17 April, 2014