Advertisement
Quick Links
Occupancy Sensor - OSFM/P, OSSM/P
Hand Held Controller - OSRC, OSRCP
Introduction
Congratulations on purchasing your new Klik Occupancy sensor
and/or hand held controller.
This product must be installed by a competent person in accordance
with the current editions of the IEE Wiring Regulations (BS7671) and
Building Regulations.
The Klik occupancy sensor responds automatically to presence and
ambient light conditions to provide a quick and efficient means of
lighting control.
The OSFM/P and OSSM/P use passive infrared technology and
combine an integral photocell to provide automatic control of light-
ing. Programming is achieved using the hand held remote control
(OSRCP), which enables easy commissioning when you have
multiple sensors, saving time during installation.
Installation and Mounting: OSFM/P Flush Mounted Version
Cut 50mm
circular hole
Installation and Mounting: OSSM/P Surface Mounted Version
OSSM/P is suitable for surface mounting. The product can be
directly mounted onto a BESA box or to any solid surface using the
fixing positions.
1. Decide upon the position for mounting the occupancy sensor.
2. Remove the top cover of the sensor by twisting the top cover
anti-clockwise.
3. Fix the ceiling-mounting bracket using the two screws provided.
4. Connect the cables to the corresponding terminals on the base
cover assembly. (see page 2 for connection diagrams)
5. Position the base cover assembly over the ceiling-mounting
bracket and rotate.
Note: This product can be installed without the need for the ceiling
mounting bracket if there is no BESA box.
4696016
v5
Maximum
35mm
Ensure there is sufficient
cable length to reach from
the chosen location to the
LDS box, Junction box or
Luminaire tray.
The time delay and lux levels can be adjusted using the hand held
programmer, without the need to even touch the sensor.
Positioning Considerations
The OSFM/P and OSSM/P should be mounted in the centre of the
group of luminaires to be controlled and the optimum all round cov-
erage is achieved with the unit mounted at a height of 2.5m. The
coverage for these sensors at this height is 6m diameter.
For Technical Support regarding this product please phone:
0870 607 6677
Open
Minimum
125mm
Secure with locking ring
before terminating the
cable into the KLDS,
junction Box or Luminaire.
Ceiling mounting
bracket
Close
Base cover assembly
Top cover
1
Advertisement
Summary of Contents for KLIK OSFM
- Page 1 This product must be installed by a competent person in accordance Positioning Considerations with the current editions of the IEE Wiring Regulations (BS7671) and The OSFM/P and OSSM/P should be mounted in the centre of the Building Regulations. group of luminaires to be controlled and the optimum all round cov- erage is achieved with the unit mounted at a height of 2.5m.
- Page 2 Connection Diagrams OSFM/P directly connected to a Klik Lighting Distribution Box (KLDS) Ensure that the supply is isolated before removing any covers of the KLDS. 1. Remove the end cap terminal cover from the KLDS distribution box. 2. Remove 20mm knockout from a suitable position for cable entry on the KLDS box.
- Page 3 OSRCP - Remote Controller for Programming and User Overriding Overview This product is a programming tool used in conjunction with OSFM/P and OSSM/P products. It can also be used to manually override the Occupancy Sensor. The programming tool OSRCP is almost identical to the user override OSRC, the only difference being the six dil switches that may be set to give the desired programme parameters.
- Page 4 Walk Test Mode Set the dil switches to the following positions to achieve the desired Default to Factory Settings modes, point at the OSFM/P or OSSM/P and press the button. Presence Detection Mode: Presence Mode with Photocell: For normal operation...