OFM 700 Assembly Instructions

Model 700 / 700-AA6
Parts Listing
A
Chair Back
1 Unit
B
Chair Seat
1 Unit
c D
Chair Base Casters
1 Unit 5 Units
E F
Gas Lift Telescopic Bellows
1 Unit 1 Unit
Big & Tall Chair
A
Seat
Mechanism
F
E
C
WEIGHT CAPACITY: 400 lbs.
Assembly Notes:
During assembly, hand tighten screw only when all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Assembly Instructions:
Tools Needed: Philips Head Screwdriver
STOP
Please read all instructions before assembly.
Step 1: Insert Casters (D) into Chair Base (C).
Step 2: Insert Gas Lift (E) into Chair Base (C).
Step 3: Cover Gas Lift (E) with Telescopic Bellows (F).
B
If you are assembling a model with optional AA-6 Arms please
STOP
proceed to subsequent pages for armrest assembly instructions.
Step 4: Carefully place Chair Seat (B) with attached seat
mechanism onto the Gas Lift (E), aligning the hole
in the seat mechanism with Gas Lift. Press down
on Chair Seat (B) to secure onto Chair Base (C).
Step 5: Slide Chair Back (A) with attached back support bar
into the slot on the seat mechanism.
Step 6: Hand tighten tension knob on seat mechanism until the
Chair Back (A) is properly secured.
Step 7: Carefully sit on chair to make sure the Gas Lift (E)
is properly inserted into the Chair Base (C).
Step 8: Operate the gas lift lever on the seat mechanism,
to be sure unt is working properly.
D
06.30.2010
161 Tradition Trail Holly Springs, NC, 27540
800-520-7471 (voice) 919-362-4765 (fax)
www.ofminc.com
919- 303-6389 (voice)
support@ofminc.com