CB440/511 Programming and Installation Instructions
Determine individual call box addresses prior to starting the
installations. Un-programmed call boxes default to address 001
(Alarm Code-1). Triggering a call box at this address may trigger an
advisory message or no action at all.
Programming the CB440/CB511 Call Box Address
1. Set the internal programming jumpers for
Address Programming:
Address
Programming
JP1
OFF
JP2
OFF
HELP
= "PRESS HERE"
2. Press and hold RESET until the LED flashes one time. (approximately 8-seconds). The unit is now
in address programming mode.
3. The HELP and RESET buttons are used to program the 3-digit address. Leading zeros are
required. HELP = digits 1-9, RESET = digit 0 and SAVE.
4. For example, program Alarm-802 as follows:
•
Press HELP 8-times, RESET once to save. (8)
•
Press RESET once to represent the zero.
•
Press HELP 2-times, RESET once to save. (2)
Note: The LED will flash with each press of the HELP button. When the RESET button is pressed
rd
to save the 3
digit, the LED will flash to indicate the address that was entered. The LED will
indicate digit zero by a long flash. (approximately 1-sec.)
5. Program each call box according to the mounting location.
6. Set the jumpers to "Disable" to prevent accidental changes and install the call box module.
CB440/511 PCA
NOTE: In both Address and Mode programming, if no buttons are pressed for 30 seconds, the
unit will timeout and return to normal operating mode. The LED will flash five times upon
exit of either mode and any changes made will be lost.
CB440/511 Programming and Install Instructions
Technical Document
Mode
Programming
Programming
ON
ON
RESET
= "small white circle"
1
Disable
ON
OFF
(0)
JP2
JP1
CB440
CB511
P/N: 430223-00 Rev R