Bayco NightStick TAC-500 Instruction Manual

Instruction Manual
TAC-500/510/550/560
US PATENT 9,713,217
THANK YOU FOR SELECTING THE NIGHTSTICK TAC!
Please read these instructions before using your TAC. They include important safety
and operation information. Be sure to charge the TAC fully before the first use. A battery
is fully charged when the charger light is green.
WARNINGS
y Lithium-ion batteries must be used and charged properly. Improper use can result in
serious injury, fire, or death.
y NOT FOR USE IN HAZARDOUS LOCATIONS. Do not use this product in explosive
atmospheres, near flammable liquids, or where explosion proof or intrinsically safe
lighting is required.
y DO NOT use this product in the proximity of vehicles or equipment when there is a
risk of flammable liquids coming into contact with the flashlight.
y Light can become hot while on. To prevent damage DO NOT cover or place next to
any potentially flammable materials while in use.
y Do not leave the battery in direct sunlight or use or store the battery inside cars in
hot weather.
y Do not expose the battery to water or salt water, or allow the battery to get wet.
y Do not store the battery with metallic objects that may cause a short circuit.
y Immediately discontinue use of the battery if the battery emits an unusual smell,
feels hot, changes color, changes shape or appears abnormal in any way.
y Keep out of the reach of children.
INITIAL USE
y Fully charge the TAC before the first use, or if the battery is new or has been unused
for several months. The maximum charge time required is approximately 4 hours.
DAILY USE
y Use only the supplied Nightstick charger, battery and AC or DC adapter. For best
performance, charge the TAC when the flashlight beam starts to dim.
y Connect the AC power adapter to the charger. The LED indicator will not be
illuminated at this point.
y With the flashlight facing forward, slide the TAC into the charger until the contacts
snap into place.
y The LED indicator changes to constant red indicating the TAC is properly inserted
into the charger and is in fact charging. The LED indicator remains red until the battery
is fully charged. At full charge, the LED indicator turns green.
y The total time to full charge the TAC varies depending on the remaining charge in
the battery pack.
y To confirm a full charge, keep the TAC in the charger and turn it on. The LED indicator
will change to red. Turn off the TAC. If the TAC is fully charged, the LED indicator will
turn green. If not, it remains red until the charge is completed and the LED indicator
turns green. The TAC will now be fully charged.
OPERATION
The TAC has five light modes: momentary flashlight, full brightness flashlight,
medium brightness flashlight, low brightness flashlight and strobe. The TAC has a single
tail switch providing access to all modes.
MOMENTARY FLASHLIGHT MODE
Lightly press the tail switch for momentary operation. Release the switch to turn the
light off.
CONSTANT-ON
Press the tail switch until it clicks and then release for constant-on in high-brightness
mode. Press and release the tail switch again to turn the light off.
SELECT BRIGHTNESS LEVEL
Press and hold down the tail switch. The light will cycle from high to medium to low
and then back up again at a rate of approximately one mode per second. The light will
continue to cycle up and down through the various modes as long as the tail switch is
held down. When the desired brightness level is reached, simply release the tail switch,
and the light will remain in that brightness mode. Pressing and holding the tail switch
Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • 1-469-326-9400 • www.nightstick.com
Included in the box - Compris dans la boîte - Incluido en la caja
again will cause the light to cycle from whatever mode it is currently in. Press and
release the tail switch to turn the light off.
STROBE FUNCTION
To activate the strobe, rapidly double click the tail switch. The strobe can be activated
from any mode including off. Press and release the body switch to turn the strobe off.
CR-123 BATTERY CARRIER
The CR123 battery carrier converts the TAC from rechargeable Lithium-ion to non-
rechargeable Lithium battery operation.
Load two CR-123 Lithium batteries with the positive terminals pointing in the direction
of the arrow. NOTE: The flashlight cannot be charged with the CR-123 CARRIER
installed.
LIMITED LIFETIME WARRANTY
Bayco Products, Inc. warrants this product to be free from defects in workmanship
and materials for the original purchaser's lifetime. The Limited Lifetime Warranty
includes the LEDs, housing and lenses. Rechargeable batteries, chargers, switches,
electronics and included accessories are warranted for a period of two years with proof
of purchase. Normal wear and failures which are caused by accidents, misuse, abuse,
faulty installation and lightning damage are excluded.
We will repair or replace this product should we determine it to be defective. This
is the only warranty, expressed or implied, including any warranty of merchantability or
fitness for a particular purpose.
For a complete copy of the warranty, go to www.nightstick.com/nightstick-product-
support/warranties. Retain your receipt for proof of purchase.
INS-T500-18