Glastender LLD Installation & Operation Information

The following information applies to Glastender LLD and LLDS
model lighted liquor display units. Please review this information
before installation and operation. Long term, trouble-free service
will follow if good housekeeping and maintenance procedures are
followed. Thank you for selecting Glastender, Inc. products.
• Electrical: 115 Volt AC, 1 Phase, 60 Hz, less than 5 Full Load
Amps. A 9-foot grounded cord is included.
U S
ncrating and
1. Unwrap power cord.
2. Position the Lighted Liquor Display.
3. Typically, displays up to 54" are shipped as a single unit and need
no further assembly. For units 60" and longer:
Remove six screws from the each top, remove tops. (Fig. 1)
Put the right LLD power cord through the side hole. (Fig. 2)
Add the provided spacer to the right LLD. (Fig. 2)
Start one screw from inside the right LLD to keep the spacer in
line. (Fig. 3)
Align the two ends of the Lighted Liquor Displays. (Fig. 4)
Put the power cord into the left LLD and plug in.
Finish the started screw, and three more to secure the units
together. (Fig. 3)
Reinstall the tops with six screws each.
4. Plug into 115 volt AC outlet.
5. Through the power cord side hole, turn the switch ON.
6. Your Glastender Lighted Liquor Display is now ready for use.
c L
hanging a ight
1. Disconnect the electrical power.
2. Unscrew and remove the top.
3. Twist the bulb, and remove.
4. Align the new bulb pins, set in and twist into position.
5. Put the top back in place and secure with screws.
No labor warranty. One year parts warranty only. If any issues occur contact the factory
immediately for assistance at 800.748.0423, 8AM to 5PM EST, Monday through Friday.
08-26-08
L
ighted
i
nstaLLation
-U i
tart p nStrUctionS
B
ULB
IMPORTANT!!
Glastender, Inc. · 5400 North Michigan Road · Saginaw, MI · 48604-9780
800.748.0423 · 989.752.4275 · Fax 989.752.4444 · www.glastender.com
L d
iquor
& o
peration
ispLay
i
nformation
6 screws for top installation
Figure 1
spacer between units
Figure 2
3 screw holes to
secure units together
Figure 3
Figure 4
power cord through
side hole
first screw started
© 2007 Glastender, Inc.