Advertisement
Quick Links
Installation Instructions for
Cirque Small
CEILING COLLECTION
G
ENERAL RODUCT NFORMATION
P
I
This product can mount to either a 4" square electrical box
with round plaster ring or an octagon electrical box.
This product is suitable for damp or wet locations.
This product can be dimmed with a standard incandescent
dimmer.
This product may be ceiling or wall mounted.
This instruction shows a typical installation.
Install the Fixture Base
1A
FIXTURE BASE
2
GLASS SHADE
1
While supporting the glass shade, loosen (Do Not
Remove) all the #6-32 set screws on the fixture base
with the 1/16 Allen wrench.
2
Carefully remove the glass out of the fixture base.
:
#6-32 SET SCREWS
1
1/16 ALLEN
WRENCH
CAUTION RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1B
Remove the mounting plate from the assembly by
3
unscrewing the two knurled nuts.
1
920CIRQSM
700
CQS
_, 700OWCQS
-
1.5
Advertisement
Summary of Contents for TECHLIGHTING Cirque Small 700CQS
- Page 1 920CIRQSM Installation Instructions for Cirque Small _, 700OWCQS CEILING COLLECTION ENERAL RODUCT NFORMATION This product can mount to either a 4" square electrical box with round plaster ring or an octagon electrical box. This product is suitable for damp or wet locations. CAUTION RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar...
- Page 2 #8-32 SCREW #8-32 SCREW MOUNTING PLATE Mount the fixture base to the ceiling by reinstalling it Install the mounting plate to the electrical box with onto the mounting plate and securing it tightly with the two #8-32 screws. the knurled nuts. For wet location installation, caulk around the fixture base with waterproof construction sealant.
- Page 3 Install the Lamp and Shade #6-32 SET SCREWS FIXTURE BASE GROOVE ON 1/16 ALLEN GLASS SHADE SOCKET LAMP WRENCH Place the glass shade into the fixture base until the C AUTION: To reduce the risk of a burn or electric shock during relamping, disconnect the power to grooved section of the glass shade is completely inside.
- Page 4 7400 Linder Ave, Skokie, 60077 847.410.4400 www.techlighting.com © 2016 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right to change specifications for product improvements without notification.