JAR Systems MD-5135 Installing

MD-5135 + MD-5150
Installing a Quick-Sense USB-C Hub
The Intelligent Charging System (ICS) is
located on the top of the cart. Remove
the blue cover by taking out the screws
on either side with the torx key. When
uncovered, unplug any connected
cables and drop the cables into the cart.
Pieces are not used in re-assembly.
Remove the four screws on either panel
on the back side of the cart with the torx
key. Keep the panels, screws, and washers
in a safe place to reuse when putting the
panels back on the cart after installation.
1
Lift the ICS up until it unclips and remove
the black mounting plate, underneath the
ICS, by unscrewing the two screws with
the torx key. Use the blue plate included
in the upgrade kit to cover the hole on
top of the cart and fasten screws with torx
key. Pieces are not used in re-assembly.
4
Once all the AC adapters are out, you
can remove the power strips. The power
strips are not used with the Quick-Sense
USB-C Hubs so they can be removed for
use elsewhere, or can remain in the station
to reduce the steps in larger projects.
www.JAR-Systems.com | 866.393.4202
2
If the cable management tray is secured,
remove the screws on the front of the
lid using a torx key and place them in a
secure spot to use later. Take out all of the
AC adapters, the back two panels of the
cart can be removed to make unplugging
from the power strip easier.
5
Locate the three screws behind the face
plate of the cable management shelves.
Remove screws and washers with the
torx key and place aside to use in a later
step. The front face plates are no longer
needed with the hubs stalled.
3
6