Advertisement
Quick Links
READYKEY K3000 / D8300 Series
Operation & Installation Guide
Figure 1: Low Profile
(K3001 / D8301)
1.0
Introduction
These readers read KeyPAC ID-devices including ISO thickness ID cards. They do not read the earlier
K2000 / D8200 series ID devices. Make sure that you specify KeyPAC whenever you buy ID devices.
1.1
Part Numbers
K3001 / K3001W and D8301 are KeyPAC Low Profile Readers
K3002 / K3002B and D8302 are KeyPAC Vandal Resistant Readers (Stainless Steel or Brass)
K3003 / K3003W and D8303 are KeyPAC Mullion Readers
Note: The K3000 Series readers are available to Readykey Dealers only.
1.2
Compatible ID Devices
The KeyPAC range will not work with the older Readykey ID devices. The following are part codes for
compatible ID devices:
Part Number
K3011-10
K3011M-10
K3010-10
K3011WG-10 / D8339-10
3010WG-10 / D8338-10
Note: The K3000 Series Devices are available to Readykey Dealers only.
2.0
Overview
2.1
Description
Each reader may be mounted internally or externally without any special weather protection, however the
Vandal Resistant Reader is better suited to outdoor use.
Other important features include:
•
Suitable for mounting on metallic and non-metallic surfaces
•
Integral red/green LED
•
Tamper protection
•
Low idle current consumption
•
Integral sounder (not Vandal Resistant)
Figure 2: Vandal Resistant
(K3002 / D8302)
Description
KeyPAC ISO Thickness Card (pack of 10)
KeyPAC ISO Thickness Card with Magnetic Stripe (pack of 10)
KeyPAC Tokens (pack of 10)
KeyPAC Cards with Wiegand Stickers (pack of 10)
KeyPAC Tokens with Wiegand Stickers (pack of 10)
Table 1: Compatible ID Devices
KeyPAC Readers
Figure 3: Mullion (K3003 / D8303)
17404 Ver 2.4/47556B
Advertisement
Summary of Contents for Detection Systems Radionics K3000 Series
- Page 1 READYKEY K3000 / D8300 Series KeyPAC Readers Operation & Installation Guide Figure 1: Low Profile Figure 2: Vandal Resistant (K3001 / D8301) (K3002 / D8302) Figure 3: Mullion (K3003 / D8303) Introduction These readers read KeyPAC ID-devices including ISO thickness ID cards. They do not read the earlier K2000 / D8200 series ID devices.
- Page 2 K3000 / D8300 Series • Output format selection. Formats available are Readykey format (default), Wiegand (26 and 34bit), Magstripe and Barcode Specifications Appropriate Reading K3001 Low Profile 0 in. – 4 in. (0 cm – 10 cm) Range for ISO Thickness K3002 Mullion 0 in.
- Page 3 K3000 / D8300 Series To check that you were successful, reconnect the power using the red and black wires (as above) and count the number of green LED flashes. The format can be determined according to the table above. MOV - Lock Suppression A metal-oxide-varistor (MOV) is provided with each KeyPAC reader.
- Page 4 The yellow wire is retained for the vandal resistant reader to allow the installer to set the output format. ID devices will not be read while the sounder is operating. © 2001 Radionics, a division of Detection Systems, Inc. 17404 Ver 2.4/47556B...