Advertisement
Quick Links
Fountains of Living Waters, Inc.
Fountain Installation Instructions For All Wall Fountains
Majestic Falls – Yellowstone
Desert Mirage
Valentino
Just to name a few....
Fountains of Living Waters, Inc.
2320 Thompson Way, Unit B
Santa Maria, CA 93455
805-349-8442 –
www.livingwatersfountains.com
Advertisement
Summary of Contents for Living Waters Majestic Falls
- Page 1 Fountains of Living Waters, Inc. Fountain Installation Instructions For All Wall Fountains Majestic Falls – Yellowstone Desert Mirage Valentino Just to name a few…. Fountains of Living Waters, Inc. 2320 Thompson Way, Unit B Santa Maria, CA 93455 805-349-8442 –...
- Page 2 These Instructions show you: • How To Make Sure You Have Everything You Need To Install Your New Fountain. • Phillips® Head Screw Driver (Power Screw Driver Optional) • Level • Pencil A THE COMPONENTS You will receive a fully assembled fountain, a Wall bracket, and the hardware to install it. Wall Bracket EZ Anchors Stainless screws...
- Page 3 Year Limited Manufacturer’s Warranty. Please read pump insert for more information. Fountains of Living Waters cannot replace pumps. Fountains of Living Waters recommend replacing the water in your fountain every 3 months. FLW Wall Fountain Installation Instructions...
- Page 4 B Installing your wall fountain 1. Hold the wall bracket up to the desired height. The top of the light valance is approximately 6-1/2” above the top of the wall bracket. Check to make sure the bracket is level and mark holes. 2.
- Page 5 3. Once you have installed the EZ Anchors, place the wall bracket over the corresponding holes and using the Stainless screws provided, mount the bracket to the wall. Before tightening the screws completely, check the level again of the wall bracket.
- Page 6 5. Check to make sure that the fountain is seated on the bracket and that its centered. 6. Fill the pan with Distilled water 1” from the bottom of the fountain face. FLW Wall Fountain Installation Instructions Page 6...
- Page 7 7. Plug your fountain in for just a few seconds and then unplug it. This will allow the water to push any air out of the pump cavity. Plug your fountain in again and allow the water to start cascading over the top of the dispersment 8.
- Page 8 9. Once the water is cascading down the face of the fountain, install the disbursement cover by setting it behind the Light Valance and lowering it onto the disbursement. There are two tabs on the cover that will rest on the face of the fountain.