XT100 Receiver; however, the units must have been configured to the same ID (XT100 only works on ID 0) Power: The XT Series transceivers can operate with any voltage source from 7.5 VDC to 12 VDC. This includes running power directly off of an SBL Series remote VCC and GND.
Page 3
Configuration All units must be on the same ID to communicate with each other. XT100 units are fixed on ID 0. XT200 units are selectable between ID 0 and 1. XT300/400 units have IDs 0 through 15 available. Set the ID DIP switch to the desired ID Set the baud rate DIP switch to match the serial device connected to the XT unit.
Page 4
Example Installations Case 1 Typical Setup: Indicator to remote using two XT300 Transceivers TX CL + CL(+) TX 422A RX 422A TX CL - (CL(-) TX 422B RX 422B Indicator XT300T XT300T Remote (CLOOP LED Blink) (RX LED Blink) (422 LED Blink) Case 2 Networked Indicators TX 422A...
Page 5
Case 4 Indicator with a closed contact switch to a SBL-4SG-XT400 TX 422A RX 422A TX 422B RX 422B Ground IO 1 Indicator XT400T SBL-4SG (422 LED Blink) (RX LED Blink) Switch (Configured for Input) (Configured for Output) (IO 1 jumper to 13 Green) Case 5 Indicator with a remote zero/print switch near the Display TX 422A RX 422A...
Repeater If the transceivers/receivers are working but you cannot get the needed range for the job site you can try to add an extra transceiver to system as a repeater unit. Mount the unit roughly in the middle of the distance with line of site to both ends.
9 Volt DC power supply for all XT Series Transceivers *Any serial devices can be connected using XT Series Wireless transceivers. PCs can be connected to printers or multiple indicators can be networked together… B-TEK remotes are not required for a wireless system.