Summary of Contents for B-TEK Scales XT Series
- Page 1 Matko Wireless Installation Manual XT Series: XT100, XT200, XT300, XT400 Wireless Manual v.2.4...
-
Page 2: Product Comparison
XT100 Receiver; however, the units must have been configured to the same ID (XT100 only works on ID 0) Power: The XT Series transceivers can operate with any voltage source from 7.5 VDC to 12 VDC. This includes running power directly off of an SBL Series remote VCC and GND. - Page 3 Configuration All units must be on the same ID to communicate with each other. XT100 units are fixed on ID 0. XT200 units are selectable between ID 0 and 1. XT300/400 units have IDs 0 through 15 available. Set the ID DIP switch to the desired ID Set the baud rate DIP switch to match the serial device connected to the XT unit.
- Page 4 Example Installations Case 1 Typical Setup: Indicator to remote using two XT300 Transceivers TX CL + CL(+) TX 422A RX 422A TX CL - (CL(-) TX 422B RX 422B Indicator XT300T XT300T Remote (CLOOP LED Blink) (RX LED Blink) (422 LED Blink) Case 2 Networked Indicators TX 422A...
- Page 5 Case 4 Indicator with a closed contact switch to a SBL-4SG-XT400 TX 422A RX 422A TX 422B RX 422B Ground IO 1 Indicator XT400T SBL-4SG (422 LED Blink) (RX LED Blink) Switch (Configured for Input) (Configured for Output) (IO 1 jumper to 13 Green) Case 5 Indicator with a remote zero/print switch near the Display TX 422A RX 422A...
-
Page 6: Troubleshooting
Repeater If the transceivers/receivers are working but you cannot get the needed range for the job site you can try to add an extra transceiver to system as a repeater unit. Mount the unit roughly in the middle of the distance with line of site to both ends. -
Page 7: Mounting Dimensions
9 Volt DC power supply for all XT Series Transceivers *Any serial devices can be connected using XT Series Wireless transceivers. PCs can be connected to printers or multiple indicators can be networked together… B-TEK remotes are not required for a wireless system.