VULCANIC 9030-02 Owner's Manual

Zone Industrielle des Chanoux - F 93330 NEUILLY / MARNE (France)
1 - APPLICATION :
Temperature regulation or limitation for liquids, gases or solids.
2 - DESCRIPTION :
- Liquid dilatation thermostat with bulb and capillary of copper for reference 9030-02 and stainless steel for
reference 9030-03.
- Potential-free inverter contact.
- Breaking capacity : 16 A / 400 VAC.
- Maximum operating voltage : 400 V.
- Differential : 2.5% of full scale.
- Connection by 6.35 Faston terminals.
- Façade mounting or on support (inside case or box for instance).
3 - PRECAUTIONS FOR USE :
- Handle the capillary with care. It must never be pierced as this could cause the final destruction of the equipment.
Allow a forming radius in excess of 5 mm.
- Check that the material of the bulb and capillary is compatible with the product being tested in the event of it
being in direct contact with it.
4 - ASSEMBLY AND ELECTRICAL CONNECTION :
4 - 1 - ASSEMBLY :
- On the support which will be receiving the thermostat (façade or attaching lug), form an 7 mm Ø hole
for accommodating the shaft of the knob and two 4 mm Ø holes (diametrically opposed) on a 22 mm Ø
radius centered on the shaft of the knob, ensuring that the equipment is turned as required (see diagram
below).
- Insert the shaft of the knob in the hole provided for the purpose.
- Place the pierced tightening washer on the support receiving the equipment then install the dial, making
sure it is properly aligned.
- Install the two attaching screws.
VULCANIC S.A. - 48, rue Louis Ampère
Tél. (33) 01.49.44.49.20 - Fax (33) 01.49.44.49.41
OWNER'S MANUAL
LIQUID DILATATION THERMOSTAT
REFERENCE 9030 - 02/03
REFERENCE Range
(°C)
9030 - 02 0 +100
9030 - 03 +50 +300
Bulb Ø Bulb L Capillary length
(mm) (mm)
6 160
6 90
UT 9030 - 02/03 - A - Issued 04/03/98
(mm)
1000
1000
1/3