Slant/Fin KICKER TK-70 Quick Start Manual

ACCESSORY KIT INSTRUCTIONS
FOR SURFACE WALL MOUNTING
Instructions for mounting The Kicker model TK-70 or
TK-90 in a surface wall mount application.
1 Change switch location. See Fig. 1.
2. Change the location of the air vent by interchanging
the 1 ⁄ " NPT plug and the air vent, both of which are
4
assembled to the coil header. See Fig. 2.
3. Attach both side panels (flange facing outward) to the
base of The Kicker with (4) #8 x
See Fig. 3.
4. Attach bottom rail, plenum and partition to each side
with (8) #8 x ⁄ " sheet metal screws provided. See
1
4
Fig. 3.
5. Assemble cabinet sides, top and cabinet bottom.
Attach to plenum with (10) #8 x
screws. See Fig. 4, Fig. 5 and Fig. 6.
6. Follow instructions packed with The Kicker for water
and electrical connections, and for operation.
7. Fasten front panel in place with (2) 8 x
metal screws provided. See Fig. 7.
Figure 1. Changing the switch location
The control switch is factory installed for kickspace (horizontal)
application. For wall mounting The Kicker in a vertical position,
remove the switch assembly and reinstall as shown.
All manuals and user guides at all-guides.com
1 ⁄ " screws provided.
4
1 ⁄ " sheet metal
4
1 ⁄ " sheet
2
PARTS INCLUDED
Part No. Qty.
250020000 1
250021000 1
250022000 1
250023000 1
250025000 1
250029000 1
250060000 1
250061000 1
250062000 2
970107000 2 #8 x
980042000 22 #8 x
Figure 2. Air vent installation
Description
Front panel
Left side
Right side
Plenum
Bottom rail
Partition
Cabinet top
Cabinet bottom
Cabinet sides
1 ⁄ " sheet metal screws
2
⁄ " sheet metal screws
1
4
Part No. 250076