Quoizel SNNL9009K Assembly Instruction Sheet

6 CORPORATE PARKWAY
, .
GOOSE CREEK SC 29445
. .
www quoizel com
Please go to www.quoizel.com
Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.
Light Source: LED 16W
Estimated Assembly Time:
Preparation: Identify and inspect all parts before beginning installation. Check package content list and diagrams below to be sure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact customer service for replacement
parts.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Package Contents
Mounting
A Screw
x 3
Fixture Body
x 1
STEP 1 - Mark the Location for the 3 Mounting Holes
A. Place the light fixture onto the post and mark the location of the 3
mounting holes on the fixture fitter onto the post with the marking
pen.
Fixture
Fitter
Post
-
STEP 2 M arking the C enter of
E ach M ounting H ole
A. Remove the light fixture. Using
the center punch and hammer
marking the center of each
mounting hole location that is
marked with the marking pen.
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
2017 QuoizelInc.
Assembly Instruction Sheet #IS-SNNL9009
For Styles SNNL9009K and SNNL9009PN
for product cleaning tips. Go to the
20-30 minutes
B
Post
Lighting
Marking Pen
Mounting
Hole
Figure 1
Figure 2
Hammer
Marking
Center Punch
Post
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
Care + Maintenance selection.
-
STEP 3 Drill Holes
A. Using the 1/16" bit and drill, drill a pilot hole completely through the
post at each (3) locations marked in step 2 above.
Figure 3
STEP 4 - Wire Connections
A. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
White wire
from outlet box
Black wire from
outlet box (or Red)
Bare, or Green
Fixture Ground wire
Fitter
from outlet box
Post
-
STEP 5 Attach the fixture to
the Post Mount
A. Place the fixture on the post
lining up the mounting holes
on the fixture fitter with the
holes on the post. Use the
Mounting Screws (A) to
attach the fixture to the post.
Your fixture is now
assembled and ready to use.
!
Enjoy
1of2
_R1
1/16" bit and drill
Post
White wire
from fixture
Black wire
from fixture
Ground wire
from fixture
Figure 4
Fixture
Fitter
A
Figure 5
RevisedDate:2017-11-03
Post
Lighting
Mounting
Hole
Post
Hole