Panasonic SL-SX325 Operating Instructions

EB GN GC YC
Matsushita Electric Industrial Co., Ltd.
Web Site: http://www.panasonic.co.jp/global/
Troubleshooting guide
Before requesting service, make the below checks. If you are in doubt about some of the check points, or if the remedies indicated in the chart do not solve the problem,
consult your dealer for instructions.
No play. ≥The HOLD function is on. Release HOLD
≥The batteries may be depleted ( ➪ page 3).
(If play is extremely short even after fully recharging the
batteries, the batteries may have exceeded their life.
Rechargeable batteries can be recharged approximately 300
times.)
≥The disc isn't correctly set.
≥The disc is scratched or dirty. (Tracks skipped.)
≥There is moisture on the lens. Wait for about an hour and
then try again.
≥The lens is dirty: clean it with a blower (recommended
product: SZZP1038C).If the lens gets marked with
fingerprints, gently wipe them off with a cotton swab.
No sound or there is a ≥Ensure the plugs are inserted firmly.
lot of noise. ≥Wipe the plugs clean with a clean cloth.
≥The elapsed playing time disappears and sound is interrupted
if bumps continue repeatedly.
Play doesn't resume from ≥This doesn't work if you open the lid while the unit is in stop
the track where play mode.
stopped at. ≥This doesn't work during random play.
≥It may not work correctly under some conditions.
Play doesn't start from ≥Random play modes may be on (➪page 4).
the first track. ≥Play resumes from the track where you last stopped play
(play may start from a different track if you change discs after
the power has been turned off).
Cannot specify point A You may not be able to specify point A or B at the end of disc.
or B.
Cannot change the If [:] or [9] is pressed before [MEMO] you cannot
anti-skip mode. change the mode.
SL-SX332 Be sure to connect other equipment through the remote
The unit malfunctions control. Speakers connected directly to the unit should have an
when connected to other impedance of 1 k≠ or less.
equipment.
The operation tone may be off ( ➪ page 4).
Cannot hear the remote
control's operation tone.
The remote control does Use only the included remote control to operate this unit.
not work properly.
p
SG
References to the remote control apply only to SL-SX332.
(➪page 4).
SL-SX332
SL-SX330
SL-SX325
Dear Customer
Thank you for purchasing this product. Before connecting, operating or
adjusting this product, please read these instructions completely. Please
keep this manual for future reference.
Note:
"EB" on the packaging indicates the United Kingdom.
This function causes the unit to ignore accidental button presses.
Set to HOLD so the unit doesn't power on accidentally or interrupt play.
The unit and remote control each have independent HOLD switches.
≥
Note on CD-R and CD-RW
This unit can play CD-DA format audio CD-R and CD-RW that have been
finalized upon completion of recording. It may not be able to play some
§
CD-R or CD-RW due to the condition of the recording.
§Finalizing is a process that enables CD-R/CD-RW players to play audio
CD-R and CD-RW.

Resume function

The player stores the track where you stopped play.
Opening the lid when the unit is in stop mode cancels the function.
Auto off function
If the unit is left in stop mode for approximately 10 minutes, the unit turns
itself off automatically.
Cannot recharge. ≥You aren't using the special rechargeable batteries (➪page 3).
≥You must insert two batteries before you can recharge them.
≥The unit must be off before you can recharge.
The AC adaptor This is normal.
becomes warm during
recharging.
The batteries are taking The batteries may take a maximum of 6 hours to recharge
a long time to recharge. under some conditions.
Play time is short after ≥This may occur after the first time you recharge the batteries
recharging. or haven't used them for a long time. Play time should be
restored after a few recharges.
≥The batteries can go flat if you leave the AC adaptor
connected after recharging is complete.
The battery indicator fails ≥The indicator does not appear when the AC adaptor is
to appear or is incorrect. connected.
≥The indicator does not appear correctly under some
conditions.
The unit stops working. Disconnect then reconnect all power sources (batteries and AC
adaptor).
Display
( The HOLD function is on. Release HOLD (➪page 4).
) ≥You haven't inserted a disc or it isn't inserted correctly.
≥You have inserted a disc this unit cannot play.
* The disc lid is open.
' The program already contains 20 tracks.
Maintenance
If the surfaces are dirty wipe with a soft, dry cloth.
≥Never use alcohol, paint thinner or benzine to clean this unit.
1
≥Before using chemically treated cloth, read the instructions that came with the cloth carefully.
Operating Instructions
Portable CD Player
HOLD
RQT7181-2B
F1203TR2064