EMS fireCell FCX-500-004 Installation Manual

Radio Hub
Installation Guide
POWER
FAULT
SYSTEM
FAULT
1 Pre installation
Installation must conform to applicable local installation
!
codes and should only be installed by a fully trained
competent person.
Ensure the radio hub is located as per the site survey.
Refer to step 3 to ensure optimised wireless performance.
If using remote aerials with this product, refer to the remote
aerial installation manual for more information.
This device contains electronics that may be susceptible to
damage from Electrostatic Discharge (ESD). Take appropriate
precautions when handling electronic boards.
3 Mounting location guidelines
For optimum wireless
p e r f o r m a n c e , t h e
following must
observed:
Ensure the radio hub is not
installed within 2 m of other
wireless or electrical
equipment (not including the
control panel).
Ensure the radio hub is not
installed within 0.6 m of any
metal work.
5 Remove cable entry points
Drill the cable entry
points as necessary.
= DO NOT use
= Available cable
entry points
©2021 EMS Ltd. All rights reserved
RADIO HUB
2 m
be
0.6 m
Radio
POWER
hub
FAULT
FIRE
Control
panel
Fire Alarm Control
Part no Product description
4 Loop Radio Hub
FCX-500-004
4 Loop Radio Hub c/w Remote Aerial Facility
FCX-500-444
2 Components
1 2 3
1
4x corner covers
4
1x radio hub PCB
4 Optional PCB removal
Remove the three circled retaining screws, before unclipping
the PCB.
HEALTHY
FAULT
SYS FAULT
LOOP 1
IN OUT IN OUT
- -
6 Fix to the wall
All five circled
fixing positions
are available for
use.
The key hole can
also be used for
locating and
fixing where
required.
Page 1 of 2
2 4x lid screws 3 1x radio hub lid
5
1x radio hub back box
RF1 RF2
RESET BACK LOGON
LOOP 2 LOOP 3 LOOP 4
IN OUT IN OUT IN OUT IN OUT IN OUT IN OUT
- - - - - -
TSD052-99 Iss 19 15/12/2021
4 5
AJM