Err 1 Sample being weighed exceeds the capacity of the balance. If TABLE OF CONTENTS error occurs when the sample is within the balance capacity, balance may be incorrectly calibrated. Introduction Description Features Unpacking Installation Environment Power Options Battery Installation AC Adapter Operation Turning The Balance On And Off...
-13- NTRODUCTION Access to the Calibration menu can be disabled using the lock out Switch This manual covers installation, operation and troubleshooting for located on the right side of the balance. ⑴ Turn the balance off and unplug the power cord. the Portable Advanced Electronic Balances, models.
⑷ Weighing Press to accept the displayed setting, when released, auto 0 TARE Platform will be displayed again. AC Adapter 8.8 Parts Counting Error Level Receptacle The parts counting error level is based on the resolution (readability) Calibration Menu Lockout Switch of the particular model balance and sample weight.
⑷ Install the 4AA alkaline battery in the battery holder, orienting the Stability Range Plus (+) and minus (-) ends as indicated on the holder. ⑸ Replace the battery cover. The tability range specifies how much a displayed weight may change while the stability indicator (unit indicator) remains ON.
⑴ Access the Sel submenu. To check the balance’s calibration, place a known mass on the center of the platform and read the displayed weight. ⑵ Press If the displayed weight differs from the known mass by more than , the display will show TARE acceptable limits, refer to the Calibration Menu and the Specifications at the grams unit indicator (g) along with the current status (ON/OFF).
8.1 Accessing the Setup Menu ⑴ Repeatedly press MODE until CON is displayed. To access the Setup menu, press and hold until SETUP is TARE ⑵ Place a container on the platform, then press . the balance TARE Displayed, then release. displays ADD 5 which is the preset reference quantity.
⑴ The Calibration menu may be locked out to prevent unauthorized SETUP access. ⑵ When calibration end, turn the Lockout switch on the right side of RESET Yes,No the balance forwards, calibration menu may be stored in balance memory SEL(Unit selection) forever unless calibration menu is changed.
This manual is also suitable for:
Es-10Es-20Es-40Es-50Es-200(a)Es-300(a)...
Show all