Summary of Contents for insize IST-SD Series
- Page 1 MN IST -SD SERIES-E www.insize.com IST-SD SERIES DIGITAL TORQUE SCREWDRIVER OPERATION MANUAL...
- Page 2 Main Function Parameter Code IST-SD50 IST-SD200 IST-SD400 Digital torque value readout +/-2.5% or +/-3% accuracy Range 10-50cN.m 40-200cN.m 80-400cN.m CW and CCW operation ±2.5% ±3% ±2.5% Peak hold and Track mode selectable Accuracy Buzzer and LED indicator for the pre-settable target torque ±3.5% ±4% ±3.5%...
- Page 3 Put on the battery cap and fasten it tightly according to the Step 1: Unit selection following figures. Pre-setting unit: cN.m Press Unit Selection: in.lb Power on and resetting the screwdriver Press Press to power on the digital screwdriver. Usually press to reset the digital screw before using it.
- Page 4 Track Mode Operation Step 3: Peak hold/Track mode selection Start (system initial) Track mode Long press Setting target torque Apply torque Set Peak/Track mode 按 键选择 Press for selection Current torque value Reach 90% of target torque Set Peak/Track mode Press Reach 90% of target torque Green LED...
- Page 5 Peak Hold Mode Operation: Maintenance Start Attention: (system initial) One year periodic recalibration is necessary to maintain accuracy. Please contact your local dealer for calibrations. Setting target torque Over-torque (110% of Max. torque range) could cause breakage or lose accuracy. Do not shake violently or drop screwdriver.
Need help?
Do you have a question about the IST-SD Series and is the answer not in the manual?
Questions and answers