Advertisement
Quick Links
RAYMOR
Classic II Rimless
VITREOUS CHINA
Couple Toilet Suite
Installation set out for Classic ll Rimless Close couple Toilet Suite
Product Code: Original Suite 133575 / STD Seat Suite 194379
SET OUT DRAWING
Remove all products from packaging:
Check the product for damage, if the product is damaged return to the store of purchase,check
the product is complete with all components required to install.
This product is to be installed by a licensed plumber,failing to do so will void warranty.This product
is to be installed as per Australian Standards and local authority requirements.
Warning:
Do not bed the pan in place using cement, concrete OR SIMILAR MARTERIAL, DOING
SO WILL VOID THE PRODUCT WARRANTY.
Toilet Suite Installation
Toilet Pan Installation
N.B The Classic II Close Coupled Toilet Suite has a fixed set out of 153mm from finished wall to
centre of outlet, if your set out is outside the 153mm do not attempt installation. A 25mm off set
Pan collar may be used however confirm fitment of the pan collar as this pan has a shrouded
outlet and some offset pan collar brands vary in size and may not fit. Tradelink will only cover
warranty on a toilet suite using a 25mm offset pan collar as greater offset pan collars can cause
toilet blockages.
1. Mark the centre line of the pan connector on the floor for 'S' trap installation.
Advertisement
Summary of Contents for Watermark RAYMOR Original Suite 133575
- Page 1 RAYMOR Classic II Rimless VITREOUS CHINA Couple Toilet Suite Installation set out for Classic ll Rimless Close couple Toilet Suite Product Code: Original Suite 133575 / STD Seat Suite 194379 SET OUT DRAWING Remove all products from packaging: Check the product for damage, if the product is damaged return to the store of purchase,check the product is complete with all components required to install.
- Page 2 2. Place the pan into position centralising the pan on your centre line, draw around the pan base and mark the entry points on the floor to where the floor fixing holes are on the side of the pan. 3. Remove the pan and drill and screw into place the floor fixing brackets, set the floor fixing brackets 15mm inside the line drawn around the base.